Why does the Check Engine light come on when the cap is loose?
This warning light can indicate a wide range of problems, some minor and others much more serious; however, if the light comes on right after filling up, it probably indicates that the gas cap is loose. It is never a good idea simply to assume that the “Check Engine” light is on because the gas cap is loose.
What does the fuel cap warning light mean?
The fuel cap light tells you when a leak has been detected in your car, most likely from a loose gas cap.
What does the Gas CAP Code mean on a car?
The gas cap code is a common diagnostic trouble code that might turn your check engine light on. I put together a video discussing a problem my neighbor had with Nissan Maxima four door sedan after they filled the fuel tank.
What to do if gas cap light comes on while driving?
If this light comes on while driving, pull over in a safe spot and re-secure the cap. Continue driving normally with the light illuminated and it should go off within a day or two. If the light doesn’t turn off, inspect the gas cap for any damage and replace it if necessary.
Why is the Check Engine light still on after tightening the gas cap?
I believe OBD II requirements is that the light will go out for a loose fuel cap after 3 ign cycles. Code will clear after 40. The check engine light was still on after eight trips, so I went to an AutoZone store and its device showed that the light probably was the result of a loose gas cap.
The fuel cap light tells you when a leak has been detected in your car, most likely from a loose gas cap.
What to do if your check engine light is flashing?
Once you’ve noticed the check engine flashing, don’t worry. If it’s for gas cap failure, the fixing will take a mere few minutes. Turn off the engine vehicle. Open the gas cap door. The door is usually locked, you’ll find a push button to unlock it.
What to do if your gas cap won’t tighten?
You can either tighten the cap and wait for the system to reset itself when it determines the problem is fixed, or you can use an OBD-II code scanner to manually reset the system. Turn off your vehicle’s engine. Push button to unlock the gas cap door, if your vehicle is equipped with a locking gas cap door.