Do you need to raise the engine mount on a Hyundai?
Yes, you should always support the engine in order to relieve pressure from the hoses, wires and the other two motor mounts. You don’t need to raise the engine more than half an inch or so. Replacing the engine mount on a Hyundai can be completed at home.
Why is my engine pressure on the high side?
Now, when the engine is on and running, and the pressure gauge still reads a high pressure on the high side while the low side pressure keeps dropping, it should be clear that the underlying issue has to do with the condenser. More specifically, there is restricted air flow in the condenser due to blockage.
How do you replace the engine mount on a car?
Remove engine mount from vehicle. Install new engine mount. Slowly lower engine down on mount. Install new engine mount nuts and torque. Then repeat procedure for opposite side mount. When replacing right side engine mount, you will have to transfer heat shield over to new mount.
What to use to tighten motor mount bolts?
Tighten bolts to 50 N.m. You may want to use medium strength thread locker ( Permatex Medium Strenth Threadlocker) on the motor mount bolts to ensure that they don’t get loose due to engine vibrations. Replacement motor mounts for Hyundai can be purchased on many sites online.
What happens when the engine is mounted lower than the transmission?
In many applications, if the engine is mounted level, the transmission output shaft will be lower than the rear axle pinion. This creates an unnecessary misalignment of the universal joints. The result is obviously driveline vibration, rapid wear and loss of performance.
Remove engine mount from vehicle. Install new engine mount. Slowly lower engine down on mount. Install new engine mount nuts and torque. Then repeat procedure for opposite side mount. When replacing right side engine mount, you will have to transfer heat shield over to new mount.
Where do you measure engine setback in drag racing?
When considering engine setback, you should first think like a drag racing sanctioning body. They regularly measure engine setback from the center of the front wheel on the long-wheelbase side (usually the left), to the middle of the front-most spark plug hole. Long wheelbase side? What’s up with that? Simple.
How to raise the deck on a riding mower?
1 Preparing To Raise The Mower Deck. Check the tire pressure. 2 Adjusting The Mower Deck. Depending on your model, you may have an adjustment lever, adjustment nuts, knob, or all of the above. 3 Adjust The Adjustment Nuts. Now, there are often two adjustments necessary to position the mower deck properly. 4 Check The Deck Wheel Height.