How do you remove the tie rod from a car?
Now carefully remove the inner tie rod end. Some cars come with a small pin that has to be removed before you can turn the rod end. Simply locate the pin and pry it out with a flathead screwdriver. Once the pin is removed, you can carefully remove the tie rod end.
Do you have to replace tie rod ends?
Check to make sure your new tie rod end is comparable to the old one. If there is any doubt that the new tie rod end is compatible with your vehicle, do not use it until you consult a mechanic. They should be approximately the same shape and size. If they are exactly the same length that is even better.
How do you replace the boot on a tie rod?
Slide the boot back onto the inner tie rod. You will have to replace the clip that you broke, as they are a one time use only. It is ideal to have one before you start the job. Once you slide the boot up the inner tie rod end and into place, fasten the new clip. Then use the pliers to refasten the second clip on the boot.
Where is the cotter pin on a tie rod?
Remove the cotter pin. This pin will be located where the tie rod end meets the steering knuckle. Use a pair of needle nose pliers to straighten out the pin and then pull it out. Throw the cotter pin away. It should not be reused. Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through.
How do you replace an outer tie rod?
Move the pinch nut up to touch the outer tie rod end. This will mark the location of your outer tie rod end and you will know how far to thread on the replacement. Do not tighten the pinch nut. If you do, you will not be able to easily turn the outer tie rod end. Remove the cotter pin.
How do you remove tie rod from steering knuckle?
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.
Where are the tie rod ends on a car?
Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.
Remove the cotter pin. This pin will be located where the tie rod end meets the steering knuckle. Use a pair of needle nose pliers to straighten out the pin and then pull it out. Throw the cotter pin away. It should not be reused. Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through.