Where is the camshaft position sensor located on the Ranger?
The Camshaft Position (CMP) sensor consists of a permanent magnet, yoke and coil. The CMP sensor is positioned next to the cam gear. As each cam gear tooth passes the sensor magnetic pick-up an AC voltage pulse is induced in the coil.
When did the 3.0L camshaft position sensor change?
Do not get this confused with a CPS which is a Crankshaft Position Sensor) Starting in 1995, the 3.0L received a distributorless ignition system (DIS).
How is the camshaft position sensor used in a powertrain control module?
The Powertrain Control Module (PCM) uses the camshaft position sensor to manage sequential fuel injection and as part of misfire diagnosis. The PCM constantly monitors the number of pulses on the signal circuit. The PCM compares the number of camshaft sensor reference pulses and the number of crankshaft position sensor reference pulses received.
How to synchronize a camshaft position sensor?
Install the hold-down clamp and bolt, then tighten the bolt to 15–22 ft. lbs. (20–30 Nm). Remove the synchro positioning tool.CAUTION: If the sensor connector is positioned correctly, DO NOT reposition the connector by rotating the sensor housing.
Where is the camshaft position sensor located on a Ford Ranger?
The Camshaft Position Sensor is attached to the top of the Camshaft Sycro Shaft. NOTE: If the camshaft position sensor housing does not contain a plastic locator cover tool, a special service tool such as T89P-12200-A, or equivalent, must be obtained prior to installation.
What happens if the camshaft position sensor is faulty?
The camshaft position sensor signal is required to sequence the injector operation to the proper cylinder timing. If the camshaft position sensor or circuit is faulty, most engines will start. However, the PCM misfire diagnostic will likely be affected.
What kind of Hall effect does a camshaft position sensor use?
The Hall-effect type uses an external power source to produce a digital signal (a “square wave,” on-or-off) and has three wires. Note: If you are new to all this, you should know that the camshaft position sensor is a different part from the crankshaft position sensor.
Where is the camshaft synchronizer located on a 1995 Ford Mustang?
Location (1995+ Ford 3.0L): The the Camshaft Syncro Shaft (Camshaft Synchronizer) is on the top back passenger side of the engine. There is a hold down bolt (#3 in diagram below) that holds it in place. The Camshaft Position Sensor is attached to the top of the Camshaft Sycro Shaft.