What kind of suspension does a Mercury Villager have?
The VX54 chassis has a 112.2-inch wheelbase (sized nearly identically to the short-wheelbase Chrysler minivans). The Villager uses MacPherson struts for the front suspension and leaf springs for the solid rear axle. The front brakes were vented discs with rear drums; anti-lock brakes were fitted as standard equipment.
When did the Mercury Villager front wheel drive come out?
Introduced alongside the Nissan Quest, the 1992 Mercury Villager was the first Mercury since 1960 produced without a Ford counterpart. The first-generation Villager uses the front-wheel drive Ford VX54 platform.
Who was the manufacturer of the Mercury Villager?
Under the terms of the agreement, the development and engineering of the vehicles was done by Nissan (in the United States); the company also supplied the engine and transmission. Ford would manufacture the vehicles in its own facility, providing components for the vehicle. Development officially commenced later that year, codenamed VX54.
What kind of seats does a Mercury Villager have?
For 1993, the Villager was offered with GS and LS trim levels, in line with Mercury sedans. The second-row seat of the GS was a two-passenger bench seat; the LS was available with either a bench seat or two bucket seats.
Where is the keyless entry module on a 93 villager?
On my ’93 Villager there is a green/red stripe wire which goes from the door lock actuator assembly to power door lock module (or the keyless entry module, if you have that). (the modules are in the center console area…) I cut this wire inside the driver’s door.
Is there an anti theft system on a Mercury?
Contrary to popular belief, Ford, Lincoln and Mercury vehicles do not come equipped from the factory with a standard alarm system. Instead, the Ford Motor Company equips its vehicles with a passive anti-theft system, known as P.A.T.S.
What was the problem with my 93 villager?
I just repaired the problem on my ’93 Villager, and it was caused when the wiring harness to the driver’s side door manual lock was pinched between the interior door panel and some metal part inside the door. The insulation wore through and was grounding the circuit against the metal part.
How to reset an anti theft system for a Mercury Mountaineer?
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.
The VX54 chassis has a 112.2-inch wheelbase (sized nearly identically to the short-wheelbase Chrysler minivans). The Villager uses MacPherson struts for the front suspension and leaf springs for the solid rear axle. The front brakes were vented discs with rear drums; anti-lock brakes were fitted as standard equipment.
For 1993, the Villager was offered with GS and LS trim levels, in line with Mercury sedans. The second-row seat of the GS was a two-passenger bench seat; the LS was available with either a bench seat or two bucket seats.
When was the last year the Mercury Villager was made?
2002 was the last model year, concluding the Ford and Nissan joint venture. The last Mercury Villager rolled off the assembly line on June 27, 2002. The 1999-2002 Villager shared the same generation Nissan Quest’s distributor, which was notorious for its defects.
What kind of engine does a Mercury Villager have?
Sharing its engine with the Nissan Maxima, the Villager was powered by a 3.0L Nissan VG30E V6 (detuned from 160 to 151 horsepower). A Jatco -supplied 4-speed automatic was the sole transmission offering. In the development of the VX54 model line, Ford requested several design changes from Nissan before it would use the engine.