Why does my Taurus se Vulcan have no AC?
99 Taurus se Vulcan engine I have no ac ~rest of system works fine . blend door works. Fuse and relays all look ok. resistor swapped out~ same as before/ no ac I attached a gauge and Freon can r134 to low pressure side. likely the unit is not low on Freon as the gauge and can are not filling into the system. It says the pressure is high.
What to do if your a / C compressor won’t engage?
HOWEVER, if you cannot turn the compressor on, you cannot recharge your AC levels (grrrr). So you need to use a paper clip to bypass the relay switch and force the clutch to engage. You can then recharge the freon and re install the relay switch and it will sense more pressure and the clutch will engage by itself. Loading…
Why does the clutch on my Taurus not engage?
The clutch does not engage. The blower blows warm air/ ambient Now before I have a shop fix it I’d like to know if there is a place to jump the compressor clutch/ engage it by bypassing the pressure switch or applying voltage direct? to see if the compressor works or not. Maybe this is stupid I don’t know.
How to troubleshoot the air conditioning in a Ford Taurus?
It can be found under the trim panel of the dashboard on the passenger side if the car. Unscrew three retaining screws and pull the blower motor off the of its mount. Start the engine of the car and allow it to run while looking at the compressor. Look for obvious signs of malfunction. Touch both of the hoses attached to the compressor.
The clutch does not engage. The blower blows warm air/ ambient Now before I have a shop fix it I’d like to know if there is a place to jump the compressor clutch/ engage it by bypassing the pressure switch or applying voltage direct? to see if the compressor works or not. Maybe this is stupid I don’t know.
What causes an AC compressor to not engage?
If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways. They can activate through a relay that’s energized directly by a proper condition of the low and high pressure switches.
99 Taurus se Vulcan engine I have no ac ~rest of system works fine . blend door works. Fuse and relays all look ok. resistor swapped out~ same as before/ no ac I attached a gauge and Freon can r134 to low pressure side. likely the unit is not low on Freon as the gauge and can are not filling into the system. It says the pressure is high.