Where is the obd2 fuse?
OBD II Systems use a standardized test connector called the Data Link Connector (DLC). It is located beneath the instrument panel somewhere between the left end of the instrument panel and 12 inches (300 mm) past the vehicle centerline.
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
Why is the OBD2 port pinout not communicating?
Thanx in advance. Here is is the OBD2 port pinout, a bad ground will prevent communication, pin 5 is a ground. See if it has a good ground. Key off and use a good 10 megaohm impedance ohmmeter to test the pin 5 to ground. If no ground the circuit is broken somewhere between the OBD2 connector and the PCM
Why is my OBD scanner not working on my GMC Sunfire?
Check your fuses, I can not remember exactly which one,but I have seen multiple times that the OBD port fuse is blown. I know some smaller GM’s (cavaliers, sunfires) are run off the electric seat fuse. The yuppie speaks the truth. Don’t ask me why GM put the OBD port on that circuit……Pull the cover and swap a fuse in that spot.
Why is my OBD2 not connecting to YouTube?
These issues include an incompatible obd2 scan tool, bad fuses, damage in the circuit board, ECU, and failed computer. OBD-II…. Non connecting data Port Issue. *FIXED* This might help you! – YouTube OBD-II…. Non connecting data Port Issue. *FIXED* This might help you! If playback doesn’t begin shortly, try restarting your device.
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
Check your fuses, I can not remember exactly which one,but I have seen multiple times that the OBD port fuse is blown. I know some smaller GM’s (cavaliers, sunfires) are run off the electric seat fuse. The yuppie speaks the truth. Don’t ask me why GM put the OBD port on that circuit……Pull the cover and swap a fuse in that spot.
Thanx in advance. Here is is the OBD2 port pinout, a bad ground will prevent communication, pin 5 is a ground. See if it has a good ground. Key off and use a good 10 megaohm impedance ohmmeter to test the pin 5 to ground. If no ground the circuit is broken somewhere between the OBD2 connector and the PCM
These issues include an incompatible obd2 scan tool, bad fuses, damage in the circuit board, ECU, and failed computer. OBD-II…. Non connecting data Port Issue. *FIXED* This might help you! – YouTube OBD-II…. Non connecting data Port Issue. *FIXED* This might help you! If playback doesn’t begin shortly, try restarting your device.