Can you replace a two piece steel drive shaft with a one piece aluminum shaft?
A very common driveshaft project has been replacing a two-piece OEM steel driveshaft with a new one-piece shaft, which is typically made from aluminum and with a larger diameter than the original. This is because one-piece aluminum shaft can help minimize launch shudder.
How to make cast aluminum parts look new?
The first step of how to make cast aluminum-look new is eye inspection. This happens by asking you how much dirt the aluminum parts have. If this is the case, you just have to rinse it with water and dry it with a clean rag. You can also use some light cleaner, such as a dishwasher cleaner.
What can I use to make aluminum engine parts?
It can be applied on any surface such as aluminum, fabric, and carbon fibers. So this product is ideal and has a super clean effect on aluminum. Another feature is that the product is safe on the gaskets, seals, and rubber hoses, unlike other solvents that may harm the rubber parts of the engine.
Can a prop shaft be replaced on a ram truck?
In addition, many Ram truck owners choose to replace their two-piece prop shaft with a large diameter, one-piece aluminum shaft to help minimize launch shudder. In this case, the center four-bolt carrier bearing support housing also needs to be entirely removed to prevent the driveshaft from rubbing up against it.
A very common driveshaft project has been replacing a two-piece OEM steel driveshaft with a new one-piece shaft, which is typically made from aluminum and with a larger diameter than the original. This is because one-piece aluminum shaft can help minimize launch shudder.
In addition, many Ram truck owners choose to replace their two-piece prop shaft with a large diameter, one-piece aluminum shaft to help minimize launch shudder. In this case, the center four-bolt carrier bearing support housing also needs to be entirely removed to prevent the driveshaft from rubbing up against it.
How do you remove the driveshaft from a Dodge Ram?
Driveshaft removal (and installation) is straightforward: Using two or three jack stands, support the front and rear ends of the driveshaft. For a two-piece driveshaft, support the center as well. Unbolt the rear U-joint or four-bolt flange on the truck’s differential pinion.
Why does Dodge Ram have one piece drive shaft?
This is because one-piece aluminum shaft can help minimize launch shudder. Many believe the central carrier bearing is a weak point of the two-piece design. In fact, Dodge has installed a one-piece driveshaft in models that previously came with two-piece units.