How to determine the correct size of a hose?
Technical Hose Fittings The nomogram below is provided as an aid in determining the correct hose size. How to use the nomogram: Determine the proper flow rate your system requires, then connect a straight edge from the selected flow rate to the recommended velocity range.
How to install a hydraulic hose and connector?
Hose and Connector Installation Guide 2 Installation Assembly Criteria – Introduction While the success of a hydraulic fluid conveyance system weighs heavily on its design, the assembly of the fluid lines is just as important to the longevity and success of the system. Fluid Lines Designers are provided with various design
Where can I find Parker technical hoses?
E-5Hose Products Division Parker Hannifin Corporation Wickliffe, Ohio www.parkerhose.com Catalog 4400 USTechnical A B C Equipment D Accessories E Technical Hose Fittings Temperature / Pressure Chart – 201, 206, 213, and 266 Hose
How to install Split flange hose and connectors?
Split Flange (Code 61) Hose and Connector Installation Guide 7 (3) Reusable Hose Assembly a. Collet-Type Coupling : The collet-type coupling (1E2189) is used on high pressure XT hose assemblies. This type of coupling requires special equipment to assemble and disassemble the coupling on the hose assembly. b.
How big is an air conditioner hose fitting?
Hose ID 5/16″, OD 3/4″ – 3/8″ Fitting Size. FH8000B. Bulk #8 Air Conditioning Hose. Hose ID 12/32″, OD 29/32″ = 1/2″ Fitting Size. FH1000B. Bulk #10 Air Conditioning Hose. Hose ID 1/2″, OD 1″ – 5/8″ Fitting Size. FH1200B. Bulk #12 Air Conditioning Hose.
What kind of fittings do cold hoses have?
We carry a full line of a/c fittings, hoses, charge adapters, and oring seals. All the fittings and hoses are indexed by size and or thread size. Cold hose has weld on barbs, compressor adapters, and much more on the specialty fittings page. If you need a custom hose please see the custom hose page for more information.
What’s the best way to tighten a JIC hose?
Tighten the nut lightly with a wrench (approximately 30 in.lb.), clamping the tube flare between the fitting nose and the sleeve. This is considered the Wrench Resistance (WR) position. Starting from this position, tighten the nut further by the number of flats from the Torque Chart.