How to install an AC compressor by Sanden?
The following AC compressor install procedure by Sanden, covers the compressor oil and refrigerant specifications, and compressor replacement steps/tips. While installing an AC compressor, be sure to follow the precautions mentioned below for a safe installation.
What should I do if my gas compressor failed?
1. Remove the oil plug from the failed compressor and drain as much oil as possible from the suction and discharge ports and from the crankcase into a suitable container. Drain for about 3 minutes while turning the front shaft nut one half turn every minute.
How to check oil level in AC compressor?
Examine the oil level in the compressor. Add oil if the level is below the normal point. Check the owner’s manual to check the correct instructions for checking up the compressor oil and level and filling it up. Unplug the single wire connector on the front side of the compressor.
How long does it take to drain an oil compressor?
Drain for about 3 minutes while turning the front shaft nut one half turn every minute. Also slightly tilt the compressor back and forth a few times to help the oil reach the oil drain hole. 2. Measure and record the amount of oil drained from the compressor. 3. Drain oil from the new compressor following step 1. 4.
How much does a Mercury Sable a / C compressor cost?
The best part is, our Mercury Sable A/C Compressor Bypass Pulley products start from as little as $30.99. When it comes to your Mercury Sable, you want parts and products from only trusted brands.
What do I need to install an AC compressor?
In this How-to article, our AC experts will cover Flushing and Evacuating the AC system, adding oil, freon and refrigerant, the drier, O-rings, the Expansion Device and the AC compressor pressure switch. You can find the video to install an AC compressor in this link: Install AC Compressor System AC compressors fail due to various reasons.
What to do if your a / C compressor is seized?
Use the fitment form at the top of the page to select your exact year and engine type for your Mercury Sable. Now there’s an affordable way to get your vehicle up and running after a seized A/C compressor renders it inoperable. Our A/C Compressor By-Pass Pulley is installed in place of a new compressor. Great saver. Great saver.
Why do I need to replace my AC compressor?
The two main causes of a faulty AC compressor are: Contamination: When debris enters the AC mechanism, it will wreak havoc in the entire system. Oil starvation: When the system is not properly lubricated, it burns out. When either of these two conditions exists, you should strongly consider an AC compressor replacement.