How to troubleshoot a problem with blow molding?
It is not, however, intended to provide a com- plete listing of all blow molding challenges and problems. For additional troubleshooting information, contact your Dow representative. In the United States, you can also call The Dow Customer Information Group (CIG) at 1-800-441-4369 or 989-832-1426.
Can a blow dryer be too hot or too cold?
Your blow dryer setting is too hot. Often times, the cooler the better. While the hottest and fastest settings may get the job done quicker, it’s not doing any good to your hair. According to Lund, this can cause too much damage and really dry your hair out.
Do You section your hair when blow drying your hair?
You’re not sectioning your hair. There’s an art to blowdrying. “Sectioning the hair is key,” said Lerma.
Why is my air blower not blowing air?
However, in some models the tubes funnel air down to a nozzle that increases the speed of the air flow. In this case, it might seem as if the blower isn’t blowing air, or isn’t blowing enough air. This can be a result of missing or damaged tubes.
Why is my blower not working in Hi ( 5 )?
The usual failure of the resistor pack is if it works in HI (5) but not in any other mode or just a few modes. When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok.
What happens if the nut on a blower comes loose?
The impeller nut attaches the impeller or fan to the crankshaft. Sometimes the impeller nut is a lock nut, but other times the nut is secured with Loctite. If the nut comes loose the crankshaft might spin without rotating the impeller.
Why is my furnace not blowing hard enough?
Furnace Not Blowing Hard Enough If the furnace blowers are generating heat in insufficient quantities, the issue is likely due to either a dirty motor or a loose blower belt. The motor can accumulate dirt over time and the gradual buildup can wear down the system. This impacts the ability of the furnace to deliver heat on a consistent basis.