When do you need to replace the clock spring?
The components include the airbag, horn, and any vehicle controls such as radio, cruise, heat and even telephone on some vehicles. The clock spring only needs to be replaced when the connectors that attach to the steering wheel airbag is melted and fused directly to the cylinder.
Can a clock spring be removed from a steering column?
Use caution as not to drop the crews down inside of the steering column. The top plate may need to be moved slightly in either direction to access all of the mounting screws. Once all mounting bolts have been removed gently grasp the clock spring and pull it from the column shaft.
How to reset the clock spring on a car?
How to reset a clock spring? 1 Start the engine and let it idle. 2 Turn the steering wheel all the way to the right. 3 Turn the steering wheel all the way to the left. 4 Repeat this procedure twice with the engine running. 5 Drive for at least 50 feet, and the steering angle sensor will reset.
Is the clock spring on my Commodore bad?
Commodore with bad clock spring. Using the scan tool to monitor the airbag loops, the resistance value is good with the steering wheel in the straight ahead position. When the steering was turned to lock the problem would appear. Loading…
Can a broken clock spring be reinstalled?
Reinstall the clock spring in the same neutral position. If you were to spin the clock spring a rotation or two and then reinstall it, you may not have enough slack in the internal ribbon before the steering wheel hits full lock. In this case, you run the risk of stretching or breaking the internal wires and damaging a perfectly good clock spring.
What happens if you spin the clock spring?
If you were to spin the clock spring a rotation or two and then reinstall it, you may not have enough slack in the internal ribbon before the steering wheel hits full lock. In this case, you run the risk of stretching or breaking the internal wires and damaging a perfectly good clock spring.
Where does the clock spring go on a steering wheel?
One part of the outer assembly follows the steering wheel, and the other part attaches to the steering column. This device is sometimes referred to as a spiral cable, airbag clock spring, steering wheel clock spring, clock spring assembly, cable reel, or contact reel, depending on the vehicle and where you live.
How much does it cost to replace a clock spring?
Clock springs are relatively inexpensive, running between $50 and $200 depending on the vehicle. Labor is fairly straightforward and should take 1-2 hours; expect to pay up to $300 in labor. If you attempt to replace the clock spring yourself, it is very important that you follow the manufacturer’s instructions for safely disabling the airbag.