Why is the rear hatch on my GMC Acadia not opening?
Could be a failure of one of the obstruction detection sensors. Someone with a scan tool and the proper software would likely be able to identify which one is causing the problem. cold weather will make weak lift gate struts– even weaker/slower. It may be cold enough- the strut is weak and the liftgate motor- find the door too heavy- and reverses.
Why is the power latch on my Acadia not working?
The original post was really helpful. Just ran into the same issue with my 2008 Acadia where the latch stopped working ( the power lift and close hasn’t worked for a year ) and after replacing the power latch, the power lift/ close is working again also! Just a couple updates:
Why is my GMC power liftgate not working?
The liftgate all of a sudden stopped latching (locking) so had to bungee cord it to keep it closed since I was on the running errands. I could hear the motor (actuator) operating but the latch just does not engage, which leads me to believe the entire mechanism is faulty.
How can I Fix my power lift gate?
So here’s how you fix it: You can now pull the plastic body panel off the inside of the gate. It will require you to pull hard, be careful to disconnect the two electrical harnesses near the latch mechanism before removing the panel completely from the car. Assemble in the opposite order.
Are there any problems with the liftgate on a GMC Acadia?
Make and Model > GMC Trucks > Acadia > Power liftgate problems on… GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
The original post was really helpful. Just ran into the same issue with my 2008 Acadia where the latch stopped working ( the power lift and close hasn’t worked for a year ) and after replacing the power latch, the power lift/ close is working again also! Just a couple updates:
How to disable the power liftgate on a GM car?
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
Could be a failure of one of the obstruction detection sensors. Someone with a scan tool and the proper software would likely be able to identify which one is causing the problem. cold weather will make weak lift gate struts– even weaker/slower. It may be cold enough- the strut is weak and the liftgate motor- find the door too heavy- and reverses.