Why does my 1973 Mercury Cougar not start?

Why does my 1973 Mercury Cougar not start?

1973 mercury cougar won’t start, just put in new battery , starter solenoid and battery cables. We jumped the solenoid and the starter works but, it … read more Vocational, Technical or Tra… F150 4×4 4.6 manual trans: The truck wont start.

Why is my Toyota starter relay not working?

I think it was somewhere around 7-8v at the solenoid. This meant that too much current was going through the ignition switch, and it was dropping too much voltage for the solenoid to work. All this does is use the ignition switch to power the relay, and not both the relay and the solenoid.

What happens when there is no power to the starter motor?

If there’s no power to the starter motor but power everywhere else you’d hear a “click!” noise when you turned to start but nothing else – ie. no whirring or cranking noises.

How is the ignition switch connected to the starter relay?

The opposite side would be connected to the starter solenoid. I connected the jumpers to the relay. Then Tucked it up out of the way. I think I need some velcro or something here to keep it in place. The Hot wire from the battery went through the firewall where the hood latch cable feeds through. I added a fuse block just in case.

Why does my starter terminal not have power?

That terminal wont have power unless the key switch is turned to start. In other words the wire with the angled boot is the power wire that triggers the solenoid and connects the power from the battery to the starter. When you release the key it cuts the power to the solenoid, releasing it, thus cutting power to the starter.

Why does my new starter relay not work?

Brand new starter relay works because I jumped the small terminal and the car cranked over. However, I noticed the last time car cranked over fine with the small terminal connected there was a little smoke that came from that same area. I am guessing I blew a fusible link or burnt a wire that is somehow wired to that small terminal.

Can a blown fuse cause a starter to not start?

Blown fuse – Sometimes the simplest explanation is the best one. A blown fuse in the starter circuit could be the cause of a no-start problem. Broken or corroded wiring – Damaged or dirty wires to the battery or to the starter solenoid (or wires that are loose) can prevent sufficient power from reaching the starter.

How is the solenoid connected to the starter relay?

In other words the wire with the angled boot is the power wire that triggers the solenoid and connects the power from the battery to the starter. When you release the key it cuts the power to the solenoid, releasing it, thus cutting power to the starter. Last edited by gregpro50; 04-04-2008 at 05:14 PM . Midland ONT. CANADA

Posted In Q&A