What is the error code for a temperature sensor failure?
Temperature Sensor Failure. The error codes above are related to a temperature sensor failure, overheat problems or a flow problem.
What are the error codes on the TPM sensor?
Sensor Error Codes 1 C0750 – Left Front Tire Pressure Monitor (TPM) system sensor not transmitting 2 C0755 – Right Front Tire Pressure Monitor (TPM) system sensor not transmitting 3 C0760 – Left Rear Tire Pressure Monitor (TPM) system sensor not transmitting 4 C0765 – Right Rear Tire Pressure Monitor (TPM) system sensor not transmitting
Why are there error codes on my pump?
Other issues that can cause these error codes is debris wrapped around the pump impeller, or one of the valves is not open up all the way.
What causes the spa side error code to go away?
Depending on where the temp sensor is mounted; usually in the wall of the spa in a sensor mount, you could have a flow issue. Shut the spa down, remove the filter and make sure all the jets are open. Then power the system back up, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
What causes the p0181 OBD-II trouble code?
P0181 is a generic OBD-II code that is triggered when the fuel temperature sensor ‘A’ circuit goes out of specifications during self-testing. This indicates that the sensor voltage fell below or went above calibrated limit specifications during the self-test. What causes the P0181 code?
When did Bank 1 O2 sensor stop working?
I have a 2002 Chrysler T&C limited. In September 2012, squirrels chewed through the wiring to my bank 1 O2 sensor. After a quick and easy fix, there were no issues or codes. In February 2013, three error codes popped up (P0134, 0138, 0139), and the car was running sluggish and getting poor gas mileage.
Why is my O2 sensor still reading the same code?
If you have to drive 10 minutes before the Check Engine light comes on with the same code with the new O2 sensors, then the O2 sensor may be getting coated or contaminated where it can no longer read the oxygen content in the exhaust gasses and the voltage signal from the O2 sensor remains high.
Is there a p0134 code on my O2 sensor?
3 replacements of O2 sensor and still have P0134 code. Now told it is the PCM – Maintenance/Repairs – Car Talk Community 3 replacements of O2 sensor and still have P0134 code. Now told it is the PCM I have a 2002 Chrysler T&C limited.