How much does it cost to replace a sway bar link?
The average cost for stabilizer bar link kit replacement is between $109 and $151. Labor costs are estimated between $44 and $55 while parts are priced between $65 and $95. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How to change the link on a sway bar?
Simple insert the lower part first, then the upper. Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer. The lower link is simply nut, mounting point, smaller nut.
What do I need to remove front wheel drive sway bar?
Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ¼-inch Allen wrench to keep the bolt from spinning.
How are sway bars attached to the car?
Sway bars contain body roll by twisting. To do this, they attach to the vehicle in four places: two frame attachment points and through two end links to the wheel. When you make a hard left turn, for instance, your car’s body is thrown to the right because the left side of the vehicle is trying to come off the ground.
How are sway bar links connected to MacPherson struts?
The switch to MacPherson struts required a change in how and where sway bar end links were connected. Confusing the matter even more, they connect upward to the MacPherson strut and are longer, or they connect to the lower control arm and are shorter.
Furthermore, it could be a problem with the sway bar links that are responsible for holding your sway bar and suspension together. If the issue does end up being with your sway bar links, the good news is that the sway bar link replacement cost is usually on the lower side.
Can you drive a car with a sway bar replacement?
You can still drive the vehicle with this problem, but it’s not advisable, especially if it is a serious malfunction. Since this is a relatively simple replacement job, you can do the work yourself and cut your costs a little bit.
How does a SWAR bar link work on a car?
A swar bar is a solid formed bar of spring steel which resists twisting and is bolted across the front and rear of a vehicle’s frame or sub-frame. Sway bar links connect the two ends of each sway bar to suspension components, so there is one sway bar link for each corner.
What are the links on a sway bar?
Every sway bar has two sway bar links connected to it. One of them is used to connect the sway bar to the left side of a suspension, while the other is used to connect the sway bar to the right side.