What was the problem with my 93 villager?
I just repaired the problem on my ’93 Villager, and it was caused when the wiring harness to the driver’s side door manual lock was pinched between the interior door panel and some metal part inside the door. The insulation wore through and was grounding the circuit against the metal part.
What are the most common problems in cars?
Top 12 Most Common Car Problems and Issues 1. Warning Lights. A warning or check engine light is the most common issue for US car, truck and SUV owners. These… 2. A Sputtering Engine. The engine runs best when air and fuel properly mix and burn in the combustion chamber. To… 3. Poor Fuel …
Where is the keyless entry module on a 93 villager?
On my ’93 Villager there is a green/red stripe wire which goes from the door lock actuator assembly to power door lock module (or the keyless entry module, if you have that). (the modules are in the center console area…) I cut this wire inside the driver’s door.
Why does my Nissan Quest Xe not come on?
1995 nissan quest xe. when i turned on the headlights, the parking lights and dashboard lights will not come on. when i turned the headlight switch to parking lights only and turn on the headlights again, parking lights and dashboard lights will come on. Intermittent problems. Does this sound like a bad headlight switch?
I just repaired the problem on my ’93 Villager, and it was caused when the wiring harness to the driver’s side door manual lock was pinched between the interior door panel and some metal part inside the door. The insulation wore through and was grounding the circuit against the metal part.
On my ’93 Villager there is a green/red stripe wire which goes from the door lock actuator assembly to power door lock module (or the keyless entry module, if you have that). (the modules are in the center console area…) I cut this wire inside the driver’s door.
Why are the lights on my dash not working?
Flip the switch or turn the dial or knob up and see if the lights on your dash come on or get brighter. If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.
Where is the dimmer switch on the dashboard?
Locate the dimmer switch for your lights. Most vehicles have a dashboard light control switch that will dim the dashboard lights as well as turn them off. Find the control switch, dial, or knob, which is generally located on the console near the steering column or may be part of the headlight switch.
What happens if you have more than 15 villagers in Minecraft?
If a village has more than 15 villagers, and at least 21 doors (including player-created ones), there is a chance that an Iron Golem will spawn within it. In some cases, a village generates a well and nothing else, this is usually more common on the console versions. Each village also has a center, where villagers mostly wander.
What happens in Chapter 1 of Virtual Villagers?
CHAPTER 1: A few lucky survivors flee from a volcanic eruption. After days of drifting in the sea, they land onto the shore of a mysterious island. CHAPTER 2: Follow two curious, determined villagers as they make their way into the darkest recesses of the cave that had long taunted them.
How does the center of the village change in Minecraft?
The center can also change by where doors are placed. If a door is placed 66 or more blocks away, a new village is created, but if it is less than 66 blocks away, it counts as a new house to the village, and the center is recalculated. This may also affect where the villagers wander.
Why does my outboard boat battery keep dying?
If your boat battery keeps dying there could be many reasons for this problem. One of the more common reasons with an outboard boat engine is that the rectifier is not working correctly. Just like the alternator on a car, the rectifier is supposed to charge your battery while the engine is running.
Why does my boat have a second battery?
You might also notice that you have a switch that can go from “battery 1” to “battery 2”. The main reason for the second battery is for an emergency where you find that your primary battery has died and you need to start the engine to get back to land.
What should I do if my heater fan switch is not working?
As long as there are no bare wires exposed, reconnect the battery cable and try running the heater fan to see if there is other diagnostic work to be done. If everything checks out, disconnect the battery again, route the switch back through the hole, and attach it with the nut.