Where is the knock sensor on a 2010 GMC Terrain?
the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles. since you are going to be buying a gasket set to do this job.
Will a knock sensor cause a miss?
There are several other symptoms indicative of a knock sensor problem. The vehicle will often shake or vibrate and misfire when the engine is started. The engine may emit strong exhaust and burning smells due to the detonation in the cylinders.
How does the knock sensor on a Chevy truck work?
The knock sensor sends a signal to the PCM (the truck engine’s computer) to tell the computer about ignition timing. The knock sensor uses two flat-response two-wire sensors. They produce voltage based on engine vibration and noise level.
What are the codes for the knock sensor?
Eventually this turns on the check engine light and sets the codes P0332 and P0327. Note that often either one or the other code will set. Regardless if one or both codes are set, not only should the two original knock sensors be replaced, but you should also replace the harness.
Is there a knock sensor problem on my Hummer?
In fact, if you have a 4.8 L 5.3 L or 6.0 L in any General Motors vehicle, including a Hummer or Pontiac, you will probably run into a check engine light indicating a defective knock sensor at some point.The check engine light registering a code P0332 or a P0327 is often the first sign you have this common problem.
Where are the knock and Ping sensors located?
It’s a piezoelectric automotive sensor that produces a small voltage signal when it hears internal engine noise that we often call knock and ping. This is why the location of the two sensors is a problem. In order to hear the engine noise reliably the sensors are buried under the intake manifold.
The knock sensor sends a signal to the PCM (the truck engine’s computer) to tell the computer about ignition timing. The knock sensor uses two flat-response two-wire sensors. They produce voltage based on engine vibration and noise level.
Eventually this turns on the check engine light and sets the codes P0332 and P0327. Note that often either one or the other code will set. Regardless if one or both codes are set, not only should the two original knock sensors be replaced, but you should also replace the harness.
In fact, if you have a 4.8 L 5.3 L or 6.0 L in any General Motors vehicle, including a Hummer or Pontiac, you will probably run into a check engine light indicating a defective knock sensor at some point.The check engine light registering a code P0332 or a P0327 is often the first sign you have this common problem.
It’s a piezoelectric automotive sensor that produces a small voltage signal when it hears internal engine noise that we often call knock and ping. This is why the location of the two sensors is a problem. In order to hear the engine noise reliably the sensors are buried under the intake manifold.