How do you reset the anti-theft on a 2007 Mercury Milan?
Try disconnecting your battery cables then wait about 10 minutes. The computer should reset itself. Reconnect the wires to the battery. It is normal for the theft light to blink about every 5 seconds when the ignition key is out or in the off position.
What to do if your Mercury Mountaineer won’t start?
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
How to reset an anti theft system for a Mercury Mountaineer?
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.
Is there an anti theft system on a Mercury?
Contrary to popular belief, Ford, Lincoln and Mercury vehicles do not come equipped from the factory with a standard alarm system. Instead, the Ford Motor Company equips its vehicles with a passive anti-theft system, known as P.A.T.S.
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
Contrary to popular belief, Ford, Lincoln and Mercury vehicles do not come equipped from the factory with a standard alarm system. Instead, the Ford Motor Company equips its vehicles with a passive anti-theft system, known as P.A.T.S.
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.