Can you remove catalytic converter in Michigan?
Removing the catalytic converter is illegal, but getting caught without one isn’t.
Is it hard to take off a Cadillac converter?
Thieves can remove a catalytic converter quickly, often in less than two minutes, so theft can even occur in broad daylight. The only tools a thief needs are a wrench (for converters that are bolted on) or a reciprocating saw (for converters that are welded in).
What tools do you need to remove a Cadillac converter?
The CAT Cutter by Holmatro is the industry’s preferred catalytic removal tool. Thanks to its low weight, the Holmatro CAT Cutter is specifically designed and ideally suited for removing the majority of catalytic converters from recycled vehicles.
Is it illegal to have a straight pipe exhaust in Michigan?
A: The law has not changed. The law does not specifically answer how loud a motorized vehicle can be, but it does say that a vehicle must have a good working muffler that prevents “excessive or unusual noise.” So any cutouts or bypasses, straight pipes or rusted-out mufflers and exhaust with holes are all illegal.
What is the security system on a 1998 Mercury Grand Marquis?
The 1998 Mercury Grand Marquis features a SecuriLock anti-theft system that immobilizes the vehicle if someone without a properly programmed key tries to start it.
Can you change transmission fluid in a torque converter?
The procedure specified in many factory shop manuals for changing transmission fluid is merely to drain and clean the sump, and then install enough new fluid to replace what was drained. But, what if you want to replace the old fluid in the torque converter, too?
How do you drain a torque converter in a car?
This is done by putting a big breaker bar and socket or very large box end wrench on the pulley nut located at the front end of the crankshaft. Then remove the drain plug and let the converter drain into a drain pan. When it’s empty, retighten to the torque figure specified in the factory shop manual.
Where is the return line on a torque converter?
There are two lines, one to the cooler and one return. Check the factory manual to identify which is the return line. If it is a flexible line, disconnect it at the transmission. If it is not a flexible line, disconnect it at the cooler. It is important to get the return line, because that empties the transmission cooler, as well.