What kind of oil pump does a transmission converter use?
Transmission Oil Pump. Transmission oil pumps provide fluid pressure for the transmission and torque converter. The valve body regulates, controls, and directs the flow of pressurized transmission fluid. Gear and rotor-type are considered fixed displacement pumps. Most pumps today are variable displacement.
Can a clogged transmission filter be a torque converter?
A restricted or clogged transmission filter makes the same whining noise as a faulty transmission pump. It’s crucial when diagnosing a transmission pump or a torque converter. Make sure the filter’s good before replacing the pump.
Can a clogged transmission filter cause a whining noise?
A restricted or clogged transmission filter will make the same whining noise as a faulty transmission pump. This is important when diagnosing a transmission pump or a torque converter. Make sure the filter is not clogged before replacing the pump.
How to do an oil change on a Mercedes?
Put 8 1/2 quarts in and reinstall the oil filter housing. Begin by safely jacking up and support your car. With the car safely off the ground you will need to remove the engine tray.
How do you change transmission fluid in a Mercedes C class?
Remove the bolts and pan to gain clearance to the transmission fluid pan. Place a drain pan of at least 10 quarts under the transmission pan drain bolt to catch the transmission fluid. Then use a ratchet with 5mm Hex bit to remove the drain bolt and allow all the fluid to drain. Figure 2. Transmission drain bolt removal.
When to do a ” drain and fill ” transmission fluid?
With a drain and fill, you are only removing about half of the fluid from the transmission via the drain bolt, replacing it, and then adding the same amount of new fluid that came out. Then, drive the car for a day or two, drain the fluid again, and replace with new fluid. The idea here is that you’re weening the car off the old fluid.
Where is the drain pan on a Mercedes C class?
There are approximately ten small bolts holding the plastic underbelly pan that protects the bottom of the engine and the transmission. Remove the bolts and pan to gain clearance to the transmission fluid pan. Place a drain pan of at least 10 quarts under the transmission pan drain bolt to catch the transmission fluid.
How do you change the fluid in a 5 speed transmission?
Remove the 5 mm bolt under the transmission using an allen wrench. Be careful as the fluid may still be hot. Drain oil from the torque converter and the transmission oil pan. Not all models have a torque converter drain bolt. The access hole for the torque converter was removed from the transmission casing in the early 2000 models.