How do you install aftermarket speakers on a Mercedes Benz?
To install aftermarket speakers, you must separate the stock speakers from their mounting brackets. These mounting brackets will be installed onto the new speaker units. With a Phillips screwdriver, remove three screws surrounding the stock speaker. Use a flat head screwdriver to pry out the speaker from the door frame.
What are the door panels on a Mercedes Benz?
This article applies to the Mercedes-Benz C-Class w204 (2007-2014). Door panels on all vehicles usually house things like the door speakers, seat controls, puddle lights, power window switches, and power mirror tilt control.
How to remove door trim on Mercedes W212?
Open the door and use a trim removal tool to pry out the armrest cover. Remove the two Hex screws with your T27 Torx screwdriver. Use the trim removal tool to pry out and loosen the A-pillar tweeter housing. The trim can then be gently removed by hand. Figure 1. Remove the door panel covers.
Do you need to remove door panel on Mercedes-Benz E-class?
The ride quality of your Mercedes-Benz E-Class is already considered the best in its class by enthusiasts and critics alike. Although it may seem as if nothing more can be done to enhance your w212, there is always the audio system. To start an upgrade of the front speakers, you must remove the door panel.
To install aftermarket speakers, you must separate the stock speakers from their mounting brackets. These mounting brackets will be installed onto the new speaker units. With a Phillips screwdriver, remove three screws surrounding the stock speaker. Use a flat head screwdriver to pry out the speaker from the door frame.
Do you need to remove the door panel on a Mercedes W212?
Although it may seem as if nothing more can be done to enhance your w212, there is always the audio system. To start an upgrade of the front speakers, you must remove the door panel. In addition to a great set of speakers, installing sound deadening material is a great way to decrease any unwanted vibrations from entering the cabin.
What to do if front passenger door speaker is bad?
For example if the speaker in the front passenger door is bad, set the majority of the sound to the rear speakers and shift the balance a little bit the the left. This is not a perfect solution but a temporary one until you get the time to replace the bad speaker. NOTE: DISCONNECT THE GROUND WIRE FROM THE BATTERY FIRST.
How do I replace the speakers in my car?
Install the door panel sliding it down and make sure it engages in the channel at the top of the door near the glass. Push the door panel in and install all the screws you removed earlier. If you need to replace one of the speakers consider replacing both speakers on each side of the car.
Why does my car stereo stop working when I open the door?
In some cases, issues with speaker wiring or speakers can also make it seem like a head unit quit working. For instance, a break in the speaker wires leading to a door speaker may cause the sound to cut out altogether, and then kick back in when the door is opened and closed again.
Can a third speaker lower the center channel?
Wiring in a third speaker will lower impedance, and if it drops too low, the amplifier may fry. If you want your center channel to be the best it can be, the doctors prescription requires the purchase of a signal processor with center-channel provisions.