Is the heater on my 2000 Vito 108 working?
My heater in my 2000 vito 108 has been on blink for a few weeks now slowing down and stopping and when I go over a bump coming back on. It has only worked on nos.1 & 4 over the last 3 years but I learned to live with it.
Where is the resister on a Mercedes Benz fan?
Just to the left of the blower motor, an electrical connector connected to a flat 1-inch-by-2-inch plate can be seen. This is the blower motor resister, which controls the fan speeds. Disconnect the multi-wire connector from the blower motor resister next to the blower motor. Start the car and turn the air conditioning on.
Where is the regulator on a Mercedes fan blower?
The Mercedes Benz fan blower motor regulator is a series of resisters in a printed circuit board about 2-inches square located right next to the blower motor.
What to do if your Mercedes heater blower is not working?
My blower motor was fixed in with 3 posidrive screws. Had to use a stubby screwdriver on one of them too due to a serious lack of room. Check first before just pulling it out Rooty.
My heater in my 2000 vito 108 has been on blink for a few weeks now slowing down and stopping and when I go over a bump coming back on. It has only worked on nos.1 & 4 over the last 3 years but I learned to live with it.
What should I do if my Vito blower is not working?
If you fancy a bit more to do while you’re in there, it’s a good idea to take out the pollen filter too, as this blocks up. My heater clears the windscreen now and the aircon works properly.
My blower motor was fixed in with 3 posidrive screws. Had to use a stubby screwdriver on one of them too due to a serious lack of room. Check first before just pulling it out Rooty.
Where is the fan on a 1999 V220 Ambiente?
Click to expand… I have a 1999 V220 Ambiente with same problem, fan sometimes works and comes on over speed bumps. I have located the motor, visible behind left hand dash vent, but can’t get at it to remove. Even when working it’s not powerful so needs replacing or new brushes, just need to remove it.