How do you remove an ignition switch from a car?
Unsnap the lower trim from the upper trim and lay the two trim pieces aside. Unbolt the electrical connector from the ignition switch using an 8 mm socket and ratchet. Unplug the electrical connector from the switch. Remove the two T-15 size Torx screws that attach the ignition switch to the steering column module and remove the switch.
How to replace the ignition switch on a Mercedes Benz?
Remove these two screws. Next remove the bezel or trim (red arrow) surround around the ignition switch. This simply unscrews counter clockwise. You should be able to do this with finger pressure but some trim pieces need a little help to get started with your trim removal tool.
How long does it take to install ignition switch in 2001 Chrysler?
With a few tools, you can install a new ignition switch in your 2001 Chrysler, right at home. From start to finish, the job should take you 35 minutes to complete. Raise the hood of your Chrysler and remove the black cable from the battery, using a socket wrench.
How do you replace a ignition switch on a 2001 Ford Expedition?
Remove the screws that connect the lower steering column trim to the steering column using a T-15 Torx driver. Unsnap the lower trim from the upper trim and lay the two trim pieces aside.
How do you remove the ignition switch from a Mercedes?
Remove the two 13 mm bolts on top of the steering column. This will allow the steering column to drop down roughly 3 inches so that you can access the release button for the ignition switch. Press the release button on the steering column where the ignition cylinder enters the column.
How do you turn off the ignition on a car?
Plug the wiring harness back onto the ignition switch. Place the lower steering column trim back into position for mounting. Return each of its screws with the Phillips screwdriver. Tighten the screws a quarter turn past hand-tight. Do not over-tighten them, as you will crack the column trim. Turn the ignition off and remove the key.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.
Pull gently on the ignition switch and remove it from the steering column. Disconnect the electrical connections from the ignition switch assembly. Disengage the connector lock on the key-in-switch and the terminal connector to remove the connector from the ignition switch.
How do you change ignition switch on Jeep Cherokee?
Press on the key cylinder retaining pin with a small screwdriver so that it matches up evenly with the key cylinder surface. Turn the ignition key to the “off” position in order to release the lock from its seated position on the switch. Turn the key back to the “lock” setting and remove the key.
Do you have to take steering wheel out to replace ignition switch?
Take the steering wheel out if it’s in the way. In some vehicles, you may be able to replace the ignition switch without removing the steering wheel. However, if you’re unable to get access to the top of the ignition switch with all the interior trim pieces removed, the steering wheel may need to come out.
Is it possible to rebuild an ignition switch?
Only some dealerships will rebuild an ignition switch and they often can’t for all vehicles, so rebuilding yours may not be an option. In that case, you will need to get a new switch from a manufacturer specific dealership that will also provide you with new ignition keys to match.