How do you install lowering springs?
- Jack up the rear of the car and put it on car stands.
- Remove the rear wheels.
- Remove the shock nuts and bolts. (You can locate them by referring to the owner’s manual.)
- Remove the springs.
- Install the new lowering springs.
- Replace the shock nuts and bolts.
- Replace the rear tires [source: Do It Yourself].
How easy is it to install lowering springs?
Installing lowering springs refers to the process of customizing your car’s suspension, enabling it to ride closer to the ground. The process is not difficult, so anyone with garage access and a little know-how can accomplish this modification.
Can lowering springs be installed upside down?
If they are lowering springs you have to reverse them. If they are coilovers, you’re OK, because they are the same throughout and flat on the upper and lower part of the coil. If you have coil springs, then yes it does matter. The springs have a flat seat on top and an offset seat on the bottom.
Which way do coil springs go in?
If they are Progressive Rate Coil Springs they will always be installed with the “tighter coils” on the top.. Just remember though.. On your (Front) aftermarket coil springs if one side is ground flat.. The “flat part” of the spring will always be installed pointing up..
How do you install lowering springs on a VW Mk6?
Bring the head of the jack up just far enough to meet the base of the strut assembly. 13) Remove the three strut mount-to-strut tower bolts. 14) Use the floor jack to slowly lower the strut assembly. 15) Disassemble the strut and install the new lowering springs. 16) Reinstall the strut assembly, reversing your steps.
What kind of lower springs do I need for my VW Jetta?
Stock or Aftermarket Dampers? The H&R spring set we have chosen is a moderate lowering kit that will drop our MKVI Jetta GLI about an inch, and still maintain ride quality.
What’s the best way to install a spring compressor?
• Wear gloves and keep your fingers out of the coils at all times. • Never stand in front of the strut bushing as you remove it. Install the spring compressors on the spring, 180 degrees apart. Try to keep the jaws on each compressor as far apart as possible while still getting a good grip on the coils.
Can you use stock struts with H & are lowering springs?
We contacted H&R about the advisability of using stock struts with their lowering springs. They responded that while they do not make recommendations about the type of damper mated to their lowering springs, their OE Sports are designed to work with an OE grade damper, or an equivalent or an aftermarket upgrade.
What’s the best way to install lowering springs?
Installing lowering springs is much the same as installing new shocks and struts. Follow these steps to get the job done: 1. Jack the vehicle up and support it with jack stands. 2. Remove the first shock/strut. You may need to loosen or remove the bottom ball joint to give enough room to swing the shock/strut free. 3.
Bring the head of the jack up just far enough to meet the base of the strut assembly. 13) Remove the three strut mount-to-strut tower bolts. 14) Use the floor jack to slowly lower the strut assembly. 15) Disassemble the strut and install the new lowering springs. 16) Reinstall the strut assembly, reversing your steps.
Where can I get a lower spring compressor?
Specialty tools, like spring compressors, are available for rent at your local Pep Boys. Installing lowering springs is much the same as installing new shocks and struts. Follow these steps to get the job done: Jack the vehicle up and support it with jack stands. Remove the first shock/strut.
What should I measure before installing Eibach springs?
Measure your vehicle’s ride height before installing Eibach Springs. This will ensure you know the amount of lowering after installation. On a level surface, measure from the upper wheel rim to the highest point of the fender well, before installation and after.