How do you reset car indicators?
How to Reset the Warning Lights on the Dash
- Open the hood of your vehicle.
- Loosen the nut that holds the negative terminal to the battery with the pliers.
- Completely remove the cable from the negative battery terminal.
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
How to reset service indicator for DIY oil change?
Posted May 25, 2005 (edited) ·. For the DIY oil change, to reset the service indicator:-. 1. Switch on ignition. (But do not start car!) 2. Select maintenance indicator (so it’s in the display) within the first 4 seconds. 3. Switch off the ignition within the display period of 10 seconds. (Maintenance should remain in the display).
How do I reset the service interval indicator?
There are two ways of resetting the service interval indicator. T4 can be connected to the vehicle and diagnostic routine performed or a manual reset procedure can performed using the trip rest button on the instrument cluster. Manual Reset Procedure. • Press and hold the trip reset button.
How do you reset the service indicator on a smart car?
Select maintenance indicator (so it’s in the display) within the first 4 seconds. 3. Switch off the ignition within the display period of 10 seconds. (Maintenance should remain in the display). 4. Push the service button (button on the left of the cluster) and hold it while you switch the ignition on. 5.
How to reset the service indicator on a Land Rover?
• Turn the ignition switch on to the ignition position II. • If the SII function is set in the CCF the information display will flash ‘SERVICE’ for 5 seconds and then display ‘SERVICE’ constantly. If the SII function is not set in the CFF the information display will show the normal odometer and trip information.
There are two ways of resetting the service interval indicator. T4 can be connected to the vehicle and diagnostic routine performed or a manual reset procedure can performed using the trip rest button on the instrument cluster. Manual Reset Procedure. • Press and hold the trip reset button.
Posted May 25, 2005 (edited) ·. For the DIY oil change, to reset the service indicator:-. 1. Switch on ignition. (But do not start car!) 2. Select maintenance indicator (so it’s in the display) within the first 4 seconds. 3. Switch off the ignition within the display period of 10 seconds. (Maintenance should remain in the display).
How do you reset the service indicator on a Mercedes?
Press the scroll forward button until “Conf. Full Serv.” is highlighted. Confirm the selection, and reset the service indicator by pressing the “OK” button. Once the service indicator is reset, place the ignition back to position “0.” Figure 6.
Select maintenance indicator (so it’s in the display) within the first 4 seconds. 3. Switch off the ignition within the display period of 10 seconds. (Maintenance should remain in the display). 4. Push the service button (button on the left of the cluster) and hold it while you switch the ignition on. 5.