How do you replace the serpentine belt on a Mercedes C class?
There is one clip holding the hose to the radiator support. It must be turned 90 degrees. There are also two clips holding the hose to the elbow. Pry these clips up to unlock them, and then pull the hose towards the front of the engine. Figure 7. The arrows point to the clips holding the intake hose. You will now need to loosen two hose clamps.
How do you remove a serpentine belt from a car?
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.
What happens when you wear the serpentine belt?
The serpentine belt powers every accessory on the engine. When it wears, belt slip occurs and it will decreases the A/C, power steering, and charging system performance. Continue reading to find out how to replace the serpentine belt on your Mercedes-Benz C-Class.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
What’s the best way to replace a serpentine belt?
Auto tensioners have either a hole that will fit a half inch drive ratchet, or a bolt you can use a socket to apply pressure to. Insert the wrench or place the socket over the bolt on the tensioner and twist it away from the belt to relieve the tension on it.
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
How is the tension set on a serpentine belt?
Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.
What happens if a serpentine belt goes bad?
The serpentine belt in most modern vehicles transfers power from the crank pulley to the various accessories mounted on the engine. A worn or damaged serpentine belt can fail to adequately transfer the power, leaving your alternator, power steering, and air conditioning failing to function.