How do you remove a headlight from a Mercedes Benz?
Connected to the headlight assembly is a large electrical harness. Simply pull on the tab to release it. Use your ratchet and socket to remove the bolts holding the assembly in place. Very gently, slip the assembly out from the front end. Figure 2. Carefully slide out the headlight assembly. Figure 3. Headlight assembly removed.
How do you install LED headlights on a Mercedes C class?
Test the headlights before reassembling the bumper and fender. Twist the knob back into place, and bolt the front bumper from under the hood. Reconnect the front plastic panel cover over the front bumper. Bolt down the bumper from the inner wheel well. Lastly, snap on the wheel well retainer clips. Figure 4. OEM LED headlight assembly installed.
How do you install HID bulb in headlight assembly?
Install the H7 HID Xenon bulb into the headlight assembly. This can be tricky because you can’t see the socket. Here are a couple of pictures that should help you install the H7 HID bulb. Make sure the HID bulb is locked in the socket. The bulb should not move. Now you need to feed 12-volt power to the ballast.
How to install HID lights on Mercedes Benz W204?
The following instructions are from installing HID lights on a W204 but these instructions are very similar to other Mercedes-Benz cars that don’t come with HID headlights.
How do you change a headlight assembly on a car?
Position the assembly so that the bracket tabs are aligned with their slots and slide the headlamp inward to engage the tabs. Replace the two bolts at the top of the assembly. If you’re replacing both assemblies, repeat these steps on the other side.
Test the headlights before reassembling the bumper and fender. Twist the knob back into place, and bolt the front bumper from under the hood. Reconnect the front plastic panel cover over the front bumper. Bolt down the bumper from the inner wheel well. Lastly, snap on the wheel well retainer clips. Figure 4. OEM LED headlight assembly installed.
Connected to the headlight assembly is a large electrical harness. Simply pull on the tab to release it. Use your ratchet and socket to remove the bolts holding the assembly in place. Very gently, slip the assembly out from the front end. Figure 2. Carefully slide out the headlight assembly. Figure 3. Headlight assembly removed.
Where is the bolt on a headlight assembly?
There’s a bolt in the upper outside corner of the assembly where it connects with the inner fender rail. The white plastic strip on the radiator side of the assembly is all that locks that side in. Pulling it up and out removes it. Pull the tabs the strip secured out of their holes in the radiator support.