What does code p0060 on OBD-II mean?
If your OBD-II equipped vehicle has stored a code P0060, it means that the powertrain control module (PCM) has detected a malfunction in the heater circuit of the downstream (or pre catalytic converter) oxygen (O2) sensor for engine bank one. Bank 2 indicates the malfunction involves the bank of the engine that doesn’t contains cylinder #1.
What causes a trouble code on a p0060 heater?
Potential causes of a P0060 trouble code may include: Burnt, broken, or disconnected wiring and/or connectors A faulty O2 sensor Blown fuse or burnt fusible link Defective engine control relay
Can a p0060 be stored in an O2 sensor?
If O2 sensor heater voltage varies from that of the battery, due to a resistance issue, A P0060 will be stored. To monitor live data from the O2 sensor heater circuit, connect the DVOM test leads to the sensor ground and battery voltage signal wires. Resistance of the O2 sensor in question may also be checked use the DVOM.
What causes the p0054 OBD-II trouble code?
This code means the Heated Oxygen Sensor (HO2S) resistance is out of range with engine bank 1 (side of engine with cylinder #1) on the sensor downstream or behind the catalytic converter. What causes the P0054 code? What are some of the symptoms of P0054 code?
If your OBD-II equipped vehicle has stored a code P0060, it means that the powertrain control module (PCM) has detected a malfunction in the heater circuit of the downstream (or pre catalytic converter) oxygen (O2) sensor for engine bank one. Bank 2 indicates the malfunction involves the bank of the engine that doesn’t contains cylinder #1.
Can a low input voltage cause code p0060?
Low input voltages may not always cause code P0060, but it is easy to misinterpret long warm-up times as resistance issues. NOTE: Avoid repairing wiring, since poorly executed repairs could cause high resistance and continuity issues later on. The better option is always to replace wiring, as opposed to repairing it.
If O2 sensor heater voltage varies from that of the battery, due to a resistance issue, A P0060 will be stored. To monitor live data from the O2 sensor heater circuit, connect the DVOM test leads to the sensor ground and battery voltage signal wires. Resistance of the O2 sensor in question may also be checked use the DVOM.
What is fault code for heated oxygen sensor?
OBD II fault code P0060 is defined as “Heated Oxygen Sensor Resistance (Bank 2 Sensor 2)”, and is set when the PCM (Powertrain Control Module) detects an electrical resistance in the sensor control circuit that falls outside of predefined parameters.