Is the seat belt on a Mercedes C300?
A technician took apart the backseat to recoil the seat belt, but as a precaution, Mercedes replaced the seat belt and we’re back in business with a fully functioning seat belt and folding backseat. The work was covered under the C300’s four-year/50,000-mile basic and powertrain warranty. Sorry, please try to sign up later.
What to do if your Mercedes seat belt won’t retract?
There are many companies in the US that provide seat belt retractor pre-tensioner repair, and recharge service. If your Mercedes-Benz seat belt won’t retract, but you know the car hasn’t been in any accident, read this article on Common seat belt problems and solutions.
Is there a problem with my Mercedes door lock?
When taken to a Mercedes specialist, this issue can be relatively easily-isolated. Vacuum door locking systems have been used in many Mercedes models for many years. Because of this, it is typical for older Mercedes models to run into issues with the various system components.
Where is the pre tensioner on a Mercedes?
A pre-tensioner may be on the other end of the seat belt as well or part of the seat buckle. You will need to remove the pre-tensioner from your Mercedes-Benz. Removing your pre-tensioner is very easy and straight forward process. Rember to disconnect the negative battery before you disconnect the pre-tensioner.
How does a Mercedes Benz door lock work?
These cars use a vacuum operated system to lock and unlock the doors. The system uses a vacuum pump mounted under the passenger seat to either suck or blow air through lines to each door. At each door, there is a vacuum diaphragm that over time can leak and eventually fail.
There are many companies in the US that provide seat belt retractor pre-tensioner repair, and recharge service. If your Mercedes-Benz seat belt won’t retract, but you know the car hasn’t been in any accident, read this article on Common seat belt problems and solutions.
How to replace the Mercedes W210 door lock actuator?
Now pry out the plastic tab holding the IRE sensor wiring harness to the door (green arrow). Also cut the zip-tie holding the harness to the mounting tab on the left of the door airbag (purple arrow). Pull off the vacuum connection going to the door lock actuator (yellow arrow). Use caution when pulling the vacuum line off.
A pre-tensioner may be on the other end of the seat belt as well or part of the seat buckle. You will need to remove the pre-tensioner from your Mercedes-Benz. Removing your pre-tensioner is very easy and straight forward process. Rember to disconnect the negative battery before you disconnect the pre-tensioner.