What kind of wire do you need for an ignition switch?
Determine which one is appropriate for your ignition switch. Connect the accessory lead wire to the “ACC” terminal of the ignition switch using the appropriate wire terminal. This wire energizes vehicle accessories such as the radio when the ignition switch is turned to the “ACC” position.
What are the numbers on the back of the ignition switch?
Locate and identify the pins on the back of the ignition switch, There should be four terminals marked “BATT” for Battery, “ST” for Start, “IGN” for Ignition, and “ACC” for Accessory. Some switches may use a different letter or number code, so check with the manufacturer of the switch to properly identify the terminals.
How can I tell if my ignition switch is positive or negative?
Some switches may use a different letter or number code, so check with the manufacturer of the switch to properly identify the terminals. Disconnect the cable from the negative battery terminal using an adjustable wrench. Identify the positive power lead to the ignition switch.
How is the starter wire connected to the ignition switch?
This wire energizes vehicle accessories such as the radio when the ignition switch is turned to the “ACC” position. Connect starter relay wire to the “ST” terminal of the ignition switch. The “ST” terminal only activates when the ignition switch is turned to the “START” position and is a spring-loaded momentary contact.
What is the color code for an ignition switch?
Orange (O) Accessory feed Ammeter to alternator or generator output and accessory fuses or switches Distribution panel to accessory switch Purple (Pu) Ignition Ignition switch to coil and electrical instruments Instrument feed Distribution panel to electric instruments Dark blue Cabin and instrument lights Fuse or switch to lights
What is the color code for engine wiring?
GENERAL WIRING COLOR CODE Color Use Green or green w/yellow stripe(s) DC Grounding Conductors Black or Yellow DC Negative Conductors Red DC Positive Conductors Engine and Accessory Wiring Color Code Colour Item Use Yellow w/red strip (YR) Starting circuit Starting switch to solenoid Brown/yellow stripe (BY) or Yellow (Y) – see note
What are the colors of a 277 volt wire?
277/480 Volt Wire Color Standards 1 Phase 1 – Phase 1 wiring should be brown. 2 Phase 2 – Phase 2 wiring should be orange. 3 Phase 3 – Phase 3 wiring should be yellow. 4 Neutral – Neutral wires should be grey. 5 Ground – Ground wiring should be green, or green with a yellow stripe. More
What are the color standards for electrical wiring?
For wires that will be 120, 208 or 240 volts, the following wiring color standards are used. It is important to note that with this type of wiring, there are multiple phases in place, each of which will get its own color wire to make it clear what it is for those working on it.