What is the left turn light on a Mercedes Benz?
The left turn light is E1e5. The 4 lamps e1, e2, e3 & e5 all share a connector, which you can remove and then check the lamp supplies with a test meter while operating the light switch & the turn switch. You should measure 12v dc at each of the 4 pins, and pin 2 should be a good earth to chassis.
Why are the turn signals on my Mercedes not working?
If none of the Mercedes turn signals work, it might be because of burned turn signal use or defective hazard lights switch. Change the fuse assigned to protect the right and left turn signal fuse. Change the hazard light switch.
Why is my brake light not working on my Mercedes?
Yes it could be the brake light switch. It could be other problems such as low brake fluid level or failed ABS wheel speed sensor. There is no certain way to know without first doing some troubleshooting. Where is the brake light swtich located on a Mercedes-Benz? Right above the brake pedal.
Why are the tail lights not working on my Mercedes?
In case the tail lights were working after the SAM was replaced but stopped after the lights were tested, this would be an indication of short circuiting. The driver for tail lights inside the module could have blown. The wiring between the Mercedes tail light and module can be checked.
Why are the rear lights on my Mercedes not working?
All the fuses are clean and new. the turn signals work, but none of the rear lights work. No brake lights, no running lights, no parking lights and no reverse lights. the bulbs are all fine.
If none of the Mercedes turn signals work, it might be because of burned turn signal use or defective hazard lights switch. Change the fuse assigned to protect the right and left turn signal fuse. Change the hazard light switch.
What should I do if my turn signal light is not working?
LED lights rarely fail. The first test that you should perform is to disconnect the LED turn signal light and apply power to the LED bulb. Does the LED light turn on? If the LED doesn’t turn on, replace it. If the LED turn signal light does turn on, the LED light is not the problem.
How can I make my Mercedes Benz reverse lights work?
We are talking of nudging the switch back or forth some 1/8-1/4 inch so it works. The NSS is adjusted correctly when the car starts in both P and N. If not it will not light up the reverse lights and you won’t be able to tell if it was the switch or the harness. The Transmission Wiring Harness?