How to remove the front axle disconnect assembly?
Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing. Now you have clear access to the front axle disconnect. Disconnect the electric plug from the disconnect assy. Remove the actuator. Remove 4 bolts holding assy to oil pan.
How to remove front axle from 2005 Envoy?
Pull wheel hub steering knuckle assembly from front axle. Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing. Now you have clear access to the front axle disconnect.
How to replace the front axle on a Toyota 4×4?
(Playback ID: NxKga1aBInfNaFur) An error occurred while retrieving sharing information. Please try again later.
How many holes do you drill in an oil pan?
Drill two .281 (9/32) holes .62 apart using the center of the casting spot face as a drill center. These holes are approximate. There is plenty of clearance to the oil pan bore. You will feel the drill pop out the back and hit the assy seal which will be discarded later.
Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing. Now you have clear access to the front axle disconnect. Disconnect the electric plug from the disconnect assy. Remove the actuator. Remove 4 bolts holding assy to oil pan.
Pull wheel hub steering knuckle assembly from front axle. Set aside on blocks under wheel well with brake line still attached. Remove right front CV axle using a brass drift and 2 lb mason hammer against tripot housing. Now you have clear access to the front axle disconnect.
How do you remove diff from Chevy Trailblazer?
Pull your axles. Unbolt the diff and shove it to the side against the frame, I used a motorcycle strap to hold it there. Unbolt the pan and pull it, then undo the motorcycle strap and out comes the diff. When dropping oil pan can I leave the diff attached to oil pan ?
Drill two .281 (9/32) holes .62 apart using the center of the casting spot face as a drill center. These holes are approximate. There is plenty of clearance to the oil pan bore. You will feel the drill pop out the back and hit the assy seal which will be discarded later.