What should I do about my GMC Acadia p0008?
“General Motors – It seems that a great many of the P0008 cases reported involve much of the lineup of GM vehicles. For most, the fix has been to replace the timing chains, including the tensioner and sliders in some cases, and to recalibrate the ECM.
How much does it cost to diagnose GMC code p0008?
The cost to diagnose the P0008 GMC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
Is the Check Engine light off on a 2009 GMC Acadia?
2009 GMC ACADIA CHECK ENGINE LIGHT OFF NOT COMMUNICATING BUT THE SCANNER GIVES ME THE FOLLOWING CODES P0008, P0016, P0017. This is the same car that had all new timing gears replaced, sensors, oil pump, etc. Did you find the recommended reading relevant to this discussion?
Where is the misalignment on a GMC Acadia?
From GM service information for P0008 and P0009: The engine control module (ECM) tests for a misalignment between both camshafts on one bank of the engine and the crankshaft. The misalignment would be at an idler sprocket for either bank or at the crankshaft.
What does the code p0008 mean on a car?
What Does the Code P0008 Mean? P0008 is the result of a test run by the engine control module to check for misalignment between the camshafts in engine bank one and the crankshaft. The misalignment for this code would be at an idler sprocket in the bank or at the crankshaft.
What kind of engine code is p0009?
Bank one is the engine is the bank that includes cylinder one. P0009 is the equivalent code for bank two. Although this code can be set by any OBD-II equipped vehicle, it is most common in Suzuki, GM, Cadillac, Buick, Holden, Chevrolet, and GMC vehicles.
Why is my ECM set to trouble code p0008?
Trouble code P0008 is most likely to be set when there is an issue with the timing chain. These are a couple of the major causes of the issue: Beyond these mechanical issues, the code could be caused by a faulty ECM. However, if this is the case, the mechanical symptoms will not appear.
What causes the OBD-II scanner error code p0008?
The OBD-II scanner error code P0008 problem is improper timing, so it will cause the engine to run rough. These are some of the most notable symptoms: The vehicle runs rough, especially when accelerating Fuel economy is lower than normal