How to replace the brake line on a Mercedes C class?
Grab the inner side of the caliper and pull it towards the rotor which creates space between the piston and rotor. Use a caliper hanger to eliminate the chance of the rubber brake line becoming damaged. Figure 9. An example of a caliper hanger (C-Class not pictured). Zip ties, coat hangers, and many other items can be used to secure the caliper.
Where are the brake rotors on a Mercedes Benz?
Identification of the braking system components. To determine if your brake rotor is in specification, locate the minimum thickness stamp on the rotor. It may be on the front, back, or side. The spec will most likely be listed in millimeters.
How do you remove rotor from Mercedes C class?
Remove the Torx bolt. The rotor will now wiggle off the hub; pull towards you as you wiggle. If the rotor is stuck, use the mallet to break the rotor free. You will have to tap the middle section of the rotor. Figure 16. Tap the rotor at the circled areas to remove it. Installation is the reverse of the removal.
How is the front caliper held on in a Mercedes Benz?
Once the wheel has been removed, turn the steering wheel to allow more clearance for the rotor. The front caliper is held on by two 13mm bolts that also have 17mm nuts. The 17mm nut needs to be held in place with the thin profile wrench while turning the bolt counter-clockwise.
Why are my brake pads soft on my Mercedes C class?
If the caliper piston does not apply evenly, uneven wear will take place on the piston face and brake pads. A tapered brake pad will create a soft pedal by initially applying only one side of the pads against the rotors. Brake pads can also become brittle and crack after prolonged use.
How do you replace front brake pads on a Mercedes?
Removing the front brake pads is easy. Simply slide them away from the rotor and out of the caliper bracket. If your new brake pads did not come with the metal clips on the caliper bracket, you can reuse the old ones if they are not damaged. Be careful removing them as they will bend easily. Carefully pry them off the bracket with your screwdriver.
Why are Mercedes C230 brake rotors so good?
The precisely machined and balanced performance brake rotors for Mercedes-Benz C230 available at AutoZone promote longer brake life. They reduce vibration because they dissipate the heat that causes warping and deposits. The hot gases are vented away, and our thermal capacity withstands high temperatures.
How do you change the brake pads on a Mercedes C class?
Location of power steering fluid, coolant, brake fluid and windshield washer. Remove the rear wheels from your Mercedes-Benz C-Class (C320, C230, C350). Remove the brake pad wear sensor from the right brake pad. Use a hammer to remove the pin that holds the brake pads in place.
How do you change the brake pads on a W203?
Remove the brake pad wear sensor from the right brake pad. Use a hammer to remove the pin that holds the brake pads in place. As you extract the retaining pin be careful to not hit the brake heat shield. If you hit the shield you may bend it and cause it to make noise when you drive. Use a screwdriver to press the brake cylinder into the caliper.
How do you change the brake fluid in a Mercedes?
Set the emergency brakes. Jack up the car using your jack. Place jack stands under the car to secure it. Open the hood and remove the cap from the brake fluid reservoir. This will allow the brake fluid to return into the reservoir when you press the pistons into the brake caliper.