Where can I buy a Mercedes door lock vacuum pump?
You can purchase the Mercedes Benz Door Lock Vacuum Pump from our online store by placing an order. There are three options need to be selected like the year, model and make of your vehicle. After selecting these options, you will be able to find all our replacement parts from our online database.
Is the fuse for the central locking pump the same on all W220 S?
Hi, yes all W220 S classes have the same fuse for the central locking pump. If the fuse is good and the reset didn’t work your pump may be bad. Make sure you removed a yellow fuse. It’s easy to miscount the fuse slots.
Where is the fuse for the central locking pump?
Fuse 62 in the rear fuse box located under the passenger side rear seat cushion is for the central locking pump. Removing the fuse and reinserting it will reset the pump in most cases.
What to do if your door lock actuator is not working?
Sitting in the car with the doors shut, press on the locking switch of the affected door lock actuator. Then operate the inside door handle and open the door. If the door lock actuator is operating correctly, opening the interior door handle will override the door lock actuator.
How to replace the door lock actuator on a Mercedes Benz?
The first step in replacing the door lock actuator is to disconnect the battery. Remove the small plastic plate at the bottom of the rear passenger seat. Underneath is a 11mm nut holding the negative terminal from the battery to ground. Remove the nut and pull the cable off.
When did Mercedes Benz start using vacuum operated locks?
Nowadays, electronics are nearly foolproof and are cheap enough to use in almost any application. Mercedes started using vacuum operated locks sometime in the 1970’s, when modern electronics were still expensive and not quite reliable enough to be used in a system that would be used so frequently.
How to replace door lock on Mercedes W210?
Remove the hook on the end of the inner door handle cable from the old door lock actuator. Pull the gasket out of the channel on the rear of the door. You want to find the small access hole inside the channel. This will allow you to access the small 4mm Allen bolt that retains the IR sensor/Door handle (green arrow).
Where is the central locking system on a Mercedes?
The locks are vacuum operated. The pump is next to the battery under rear seat. Do you hear the pump starting when you press the remote, or dash button? 1994 E320 Wagon,1999 E320 Wagon,2000 E 320 Wagon, MGB Track/Rally, ,1988 300E ,more…. Resolved his problem.