How big of a radiator do you need for a Mercedes?
Below is a list of parts and tools that you will need to change the radiator on most Mercedes-Benz vehicles. Between 3 and 4 gallons. Check capacity in your owner’s manual. Mix Anti-freeze coolant and distilled water in a 50-50 ratio. Most Mercedes have the transmission cooler integrated into the radiator.
How do you change a Mercedes Benz radiator?
Open the drain plug on the driver’s side of the radiator and allow the engine to cool down. Make sure to have a drain pan under the radiator. On some models, the drain plug is red. Pry out the two plastic pins at each end of the top radiator bracket. Remove the upper radiator support.
Where is the radiator connector on a Mercedes?
It is clipped to the bottom of the top radiator bracket. Locate the electrical connector on the back of the cooling fan. Mercedes E550 Cooling Fan Connector Location – Passenger side, behind the fan. Press the connector and pull it to disconnect it. Remove two U clips at each top corner of the radiator.
Where is the cooling fan on a Mercedes E550?
Mercedes E550 Cooling Fan Connector Location – Passenger side, behind the fan. Press the connector and pull it to disconnect it. Remove two U clips at each top corner of the radiator. These clips can be removed by prying them up with a screwdriver. Slide the radiator colling fan up.
When did the Mercedes-Benz ML 320 come out?
No accident or damage reported to CARFAX… 1st owner purchased on 10/11/07 and owne… Last serviced at 174,104 miles in Frankl… 1st owner drove an estimated 16,238 mile… No accident or damage reported to CARFAX…
Can you replace a compressor on a ML320?
Have replaced a compressor on a 2WD ML320 before from the bottom, but the ML350 4Matic eliminated the ability for this approach – so a top down view was needed with removal of the PS system.
How much does it cost to replace a ML350 condenser?
At a minimum, replace the compressor and condenser – filled with correct PAG 100 oil ($10), evacuate and recharge with fresh 134a refrigerant ($36). For parts, DENSO is the OEM for the ML350. Called DENSO to order correct model, but they were out of stock.
Below is a list of parts and tools that you will need to change the radiator on most Mercedes-Benz vehicles. Between 3 and 4 gallons. Check capacity in your owner’s manual. Mix Anti-freeze coolant and distilled water in a 50-50 ratio. Most Mercedes have the transmission cooler integrated into the radiator.
Open the drain plug on the driver’s side of the radiator and allow the engine to cool down. Make sure to have a drain pan under the radiator. On some models, the drain plug is red. Pry out the two plastic pins at each end of the top radiator bracket. Remove the upper radiator support.
What happens when coolant is low on a Mercedes?
When the coolant level is low in your Mercedes you will experience a coolant level warning light that will appear on the dash (Instrument Cluster, Gauge Area). Before topping off your coolant you’re going to want your engine to be lukewarm or cold.
What are the part numbers for Mercedes coolant?
(Mercedes-Benz coolant part numbers A0009892825, Q1030005, BQ1030005). Mercedes coolant specification MB 325.6 is the premix specification and meets all the same specification and OE part number requirements as the MB 325.5 specification mentioned above.