What happens when the PCV valve fails on a car?
This is because the pressure in the crankcase may increase when the PCV valve fails, so the oil is pushed out through the seals and gaskets since there’s no other way for the pressure to be released. The leak will cause your vehicle to burn oil and leak oil beneath your vehicle.
Why does my GMC Sierra 1500 stall at high RPM?
At higher rpm seem almost like the exhaust is clogged but the cat has been bored, itll rev up but just wont really go. Today experienced a poping sound almost like a backfire from underneath. After the truck starts and is warm at a stable idle in park/neutral it’ll rev up fine.
What does rough idle mean on a GMC Sierra?
rough idle, stalling, loss of power. o2 sensor code 44 (lean) Replaced: coolant temp sensor, tps, map sensor, fuel filter, and o2 sensor. It will run normal on occasion but only lasts about 45 seconds or so.
When is it time to replace the PCV valve?
Most PCV valves contain a spring-loaded device. Once you remove the valve, shake it with your hand. You’ll hear a rattle. If you don’t, it is time to replace the valve. Even if the valve rattles, if your engine is experiencing one or more of the bad PCV valve symptoms described above, it’s a good idea to replace the valve.
When to replace the PCV valve on a GM Truck?
Remove the PCV valve and inspect the hose going to the intake manifold for signs of excessive oil being present. If excessive oil is present in the PCV hose, replace the PCV valve (Type 948C) (2) with a new-style fixed orifice PCV valve, GM P/N 12572717 (1).
What was the problem with my GMC Sierra?
August 2007, Brought truck into dealership and they figured it was a weak fuel pump and was replaced, September 2007 stalling of engine continued. NOV. 2007 dealership replaced ignition harness, and stalling continued. Dec. 2007 I replaced the battery and did a thourough cleaning of the battery terminals.
What to do if your GMC Sierra stall?
If its a mechanical problem with the spring or pintle in the valve, it will not set a code for the IAC. If you decide to replace it. Your PCM will have to go through the relearn. Another words, it may take up to 5 miles of driving or 15 minuts for the idle to stop fluctuating. Good luck
What causes a GMC Sierra 1500 to have a lean idle?
Vacuum leaks can cause a lean condition and/or possibly a high idle. Check for cracked hoses a bad gasket or a faulty EGR or PCV Valve. 70 people found this helpful. The only other thing that will cause a lean condition is low fuel pressure. A vacuum leak will be problematic at idle and go away with higher rpms.