Where are the driveshaft bolts located on a Mercedes?

Where are the driveshaft bolts located on a Mercedes?

Locate the driveshaft bolts at the cv joint. Note that Mercedes-Benz typically uses constant velocity (CV) joints at the driveshaft and not universal joints. Remove them one at a time. Note that you may need to turn the driveshaft to get to the top bolts.

How do you replace a Mercedes drive shaft?

Spray penetrating oil at the joint and wait for at least 10 minutes before you try to disconnect the driveshaft. Install the new propeller shaft on reverse order. Tighten the bolts on a cross pattern to the specification. The typical torque specification is 40 Nm, but you should verify this value by calling the dealer.

Where is the propeller shaft on a Mercedes?

In this guide, you will find instructions on how to replace the Mercedes-Benz propeller shaft, also known as the driveshaft. The propeller shaft on Mercedes cars is part of the driveline and connects the transmission output shaft to the rear differential on rear-wheel-drive vehicles.

What should the torque be on a Mercedes drive shaft?

Tighten the bolts on a cross pattern to the specification. The typical torque specification is 40 Nm, but you should verify this value by calling the dealer. Once you are done installing all the bolts, give them a 90-degree turn to finish the installation.

Where is the flex disc located on a Mercedes?

The front flex disc. The one in the front connects the tranny to the driveshaft while the one in the back connects the driveshaft to the differential. The rear flex disc. The rear is easier to find, as it is conveniently located between the drive shaft and the rear differential.

Are there any problems with the Mercedes balance shaft?

Mercedes Benz Engine Defect Class Action Settlement. There was a lawsuit against Mercedes-Benz USA LLC where the plaintiffs allege that Mercedes produced certain vehicles with defective gears in their balance shaft for the M272 and defective idle gears in the M273. Case Name: Majeed Seifi, et al.

How much does it cost to replace Mercedes flex disc?

Mercedes Flex Disc Replacement Cost. If you have an auto repair shop replace the flex disk on your Mercedes-Benz expect to pay between $300-$500 depending on your location and model of MB. If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk.