What does the p0002 code mean on an engine?
What the P0002 code means P0002 is a generic OBD-II code indicating an issue with the engine control module (ECM) reading signals from your fuel pressure regulator on your fuel injection rail mounted to your engine.
What does trouble code p0203 on OBD-2 mean?
What does that mean? This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles. Although generic, the specific repair steps may vary depending on make/model. P0203 means that the PCM detected a fault in the injector or the wiring to the injector.
What does it mean when PCM says p0203?
Although generic, the specific repair steps may vary depending on make/model. P0203 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero.
How do you repair a p0002 fault code?
The most common procedure to repair the P0002 code are as follows: Connect a professional scan tool. Verify the code exists. Check for any other fault codes. Clear the fault codes to see which codes return. Analyze scan tool data from the ECM. Road test the vehicle while analyzing the scan tool data from the ECM.
What the P0002 code means P0002 is a generic OBD-II code indicating an issue with the engine control module (ECM) reading signals from your fuel pressure regulator on your fuel injection rail mounted to your engine.
What does the ECM do for a p0352 code?
The ECM sends a ON/OFF signal to energize the ignition coil to create a spark at the spark plug when a spark is required at the cylinder. Need more information on how to fix the P0352 code?
How to find out if your car has a p0352 code?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0352 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city.
What causes the p0022 OBD-II trouble code?
P0022 is the OBD-II generic code which indicates that the Engine Control Module (ECM) has determined the intake camshaft timing for bank 2 is more retarded than what the ECM has commanded it be. This over-retarded timing condition could be during the advancing or retarding phase of the camshaft timing. What causes the P0022 code?