Do you need to replace the drive belt on a Mercedes?
While it is not required to replace the drive belt, it makes sense to replace it simultaneously as the tensioner. It is ok to reuse the old belt if it does not show wear, cracking, degradation, or drying. Park, your Mercedes-Benz, set the parking brakes, and allow the engine to cool down.
How much does it cost to change a Mercedes belt tensioner?
The average price to change the belt tensioner at the dealer ranges between $400-$650. Local repair shops will charge between $280-$450. The DIY cost to change the Mercedes-Benz drive belt tensioner ranges between $50-$120, even if you have to buy the tools needed for this job and a new serpentine belt.
How to repair a Mercedes serpentine belt W164?
If playback doesn’t begin shortly, try restarting your device. I like repairing my own vehicles… I know you do as well. These videos will make your experience more pleasant.
How do you remove a tensioner from a Mercedes?
Remove the top Torx bolt using an E12 Torx socket and a 2″ extension. Remove the lower Torx bolt. Some models also have a shock attached to the tensioner. Remove the upper bolt from the shock to disconnect it from the engine block.
While it is not required to replace the drive belt, it makes sense to replace it simultaneously as the tensioner. It is ok to reuse the old belt if it does not show wear, cracking, degradation, or drying. Park, your Mercedes-Benz, set the parking brakes, and allow the engine to cool down.
What’s the best way to replace a serpentine belt?
Auto tensioners have either a hole that will fit a half inch drive ratchet, or a bolt you can use a socket to apply pressure to. Insert the wrench or place the socket over the bolt on the tensioner and twist it away from the belt to relieve the tension on it.
The average price to change the belt tensioner at the dealer ranges between $400-$650. Local repair shops will charge between $280-$450. The DIY cost to change the Mercedes-Benz drive belt tensioner ranges between $50-$120, even if you have to buy the tools needed for this job and a new serpentine belt.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
What happens if the serpentine belt breaks on a Mercedes Benz?
If the belt breaks, your vehicle will drain the battery and the engine will eventually die. Continue reading to avoid this by learning how to replace the serpentine belt on your Mercedes-Benz E-Class or C-Class.
How do you remove a serpentine belt from a car?
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
How can I increase the tension on my serpentine belt?
Increase the tension on the belt. If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt.