What is CSoT fault code for Mercedes SL500?
Previously I had a system fault code of c1525 systme pressure too low,I replaced the ABC filer in expansion reservoiw which csot about $2,134 to service.The dealer recommend to replace bot hthe front and rear valve blocks due to lates fault codes c1525-001-0002-004. This will cost $5,000.
What does ABC warning light on Mercedes SL500 mean?
I replaced the tandem pump and the car was fine, for about two days! Now, the “ABC warning” light comes on in red, saying “car too low”. the suspension will raise one side of the car, and lower the other. Or, sometimes, the car will run just fine.
What are the codes for Mercedes Benz CL500?
Code C1525-004 No apparent leaks, does not drop after days of sitting, Symptoms are: rear end is high especially when parked – about 3 fingers from tire to wheel arch on Right Rear and about 4 fingers…  read more Chad Farhat Owner Associate Degree
How much does it cost to replace front valve block on Mercedes SL500?
A dealer who is the oldest in it’s county. Well after their evaluation, I needed to replace the front valve block (which handles the left and right front suspension). The part alone is about $2100 and 8-10 hrs labor. Estimating around $4000 plus the 10-11 liters of Pentosin fluid. Another $380-$400.
Which is the ABC code for Mercedes CL500?
C1525-002 are the codes that show for the ABC P2001. P203a-008 are the others C1531-004. C1525-002 are the codes that show for the ABC P2001. P203a-008 are the others – Answered by a verified Mercedes Mechanic We use cookies to give you the best possible experience on our website.
When did the ABC system start on my Mercedes SL500?
In July of 2014, I purchased a used 2003 Mercedes SL500 with 80,000 miles on it. And within days the infamous “ABC Drive Carefully” message started appearing on the dash.
What’s the fault code for a 2001 Mercedes Benz?
Click to expand… For the ML class it does not apply to the 2001 models. Also the fault code in the bulletin is for DTC B9103 and DTC B9123. No others would be covered by the DTB. Post # 34 in this thread lists the DTB the parts, and all affected models.
How does Mercedes lowers the drops when parked?
Mercedes lowers drops on rear or front. When the car is parked the airmatic will try to level the car. It does this by discharging air from the airmatic suspension strut that is too high. Typically the car is leveled by lowering the one or two corners of the car that are too high.
Mercedes lowers drops on rear or front. When the car is parked the airmatic will try to level the car. It does this by discharging air from the airmatic suspension strut that is too high. Typically the car is leveled by lowering the one or two corners of the car that are too high.
How can a car sit lower on one side?
On the drivers side, the measurment was just under 62cm, but the passenger side it was bang on 63cm…. How can there be a differnce of around 10-12mm???
What to do if your GM Truck is not sitting level?
If the difference from left to right for P and R height is 15 mm (0.59 in) or less, no repairs are suggested as the vehicle is within specification. If the difference exceeds 15 mm (0.59 in) for either measurement, install the spring spacer to the left rear side of the vehicle following the procedure below.
What does it mean when your car sits low?
Please discard Corporate Bulletin Number 06-03-06-005 (Section 03 — Suspension). Have commented that their vehicle appears to lean. In most cases, the vehicle will sit low left front or high right rear. Measure fender wheel-opening heights, front and rear, to quantify vehicle lean.