How is wheel bearing adjustment and preload done?
With the indicator tip against the end of the spindle, set the indicator to zero. Grasp the rotor at 3 o’clock and 9 o’clock and begin oscillating the rotor back and forth. While oscillating, push the rotor in and read the dial indicator. Then pull the rotor while still oscillating and reread the dial indicator.
How do you remove a wheel end bearing?
Jerk the rotor or drum assembly to loosen the washer and outer wheel bearing (brakes may have to be backed off). Push the assembly back on the spindle. 5. Remove the adjusting nut, washer and outer wheel bearing (ig. 3). 6. Pull the drum or rotor assembly straight off the spindle.
Can you put new bearings on front wheel?
Bearings and races come as matched set — old bearings should NEVER be installed on new races and vice versa. Loosen the lug bolts/nuts on the front wheels. Raise the vehicle and support it securely on jackstands. Spin each wheel and check for noise, rolling resistance and freeplay. The wheels should turn freely without binding.
Where are the repackable bearings located on a car?
For example, if your vehicle is a front wheel driving car then the repackable bearings are in the rear wheels and if the vehicle is a rear wheel driving vehicle then the repackable bearings will be in the front wheels. The driving wheels have mainly sealed bearings. As a result, it is always about the non driving wheels.
What do I need to replace my front wheel bearing?
- Wheel bearing assembly
- Breaker bar
- Jack
- Socket set
- Ratchet
- Screwdriver
- Rubber mallet
- Sandpaper
When does a wheel bearing need to be replaced?
Most wheel bearings are sealed at the factory and don’t typically require replacement until around 150,000 miles or 240,000 kilometers, but there are some cars on the road whose wheel bearings do require regular service.
How do you change wheel bearings?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.
What does it cost to replace wheel bearing?
How much does it cost to replace a wheel bearing? For most vehicles, wheel bearing replacement cost is usually between $125 and $750 , and rear-wheel bearing replacement cost is usually the same as a front wheel bearing replacement. For example, you might pay between $125 to $750 at your local mechanic for both labor and parts needed to replace the wheel bearing, with a 12-month warranty, whereas a Midas will most likely charge you between $125 and $650 for the same exact service on similar