How do you drain the radiator on a VW Tiguan?
When you have brushed the exterior, find the bleed screw accessible on one of the sides at the bottom of the radiator, this will allow you to drain the radiator. To do this, position a basin under the automobile to be able to recover and recycle the coolant that will flow out during the purge.
How to do a coolant flush on a Tiguan?
Coolant Flush How-to: Volkswagen Tiguan (2009-2017) – 2011 Volkswagen Tiguan SE 2.0L 4 Cyl. Turbo 1. Getting Started – Prepare for the repair 2. Overview – How to determine cooling system type
Where is the coolant reservoir on a Volkswagen Tiguan?
The video above shows you where the coolant reservoir in your Tiguan is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Volkswagens, it will typically be in a section titled Fluid Capacities in the back of your manual.
How to flush coolant in Audi TT quattro?
Drain Coolant – Drain the coolant from the system 8. Circulate Water – Run engine with distilled water and flush 9. Fill Coolant – Dilute coolant with distilled water and fill 10. Locate Hoses – Locate the coolant hoses and connection points 11. Burp System – Remove excess air in the cooling system 12.
The video above shows you where the coolant reservoir in your Tiguan is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Volkswagens, it will typically be in a section titled Fluid Capacities in the back of your manual.
Coolant Flush How-to: Volkswagen Tiguan (2009-2017) – 2011 Volkswagen Tiguan SE 2.0L 4 Cyl. Turbo 1. Getting Started – Prepare for the repair 2. Overview – How to determine cooling system type
Drain Coolant – Drain the coolant from the system 8. Circulate Water – Run engine with distilled water and flush 9. Fill Coolant – Dilute coolant with distilled water and fill 10. Locate Hoses – Locate the coolant hoses and connection points 11. Burp System – Remove excess air in the cooling system 12.
What’s the best way to flush a VW radiator?
Drill a 1/8 or 1/16 inch hole in the lip of the replacement thermostat. Insert it then the “new” o-ring with the cover, use only a 10mm 6pt 1/4 in drive socket and DO NOT HONK, snug it up, it only takes 17 inch pounds of torque.. (and it is cheaper to buy full strength and cut it your self than buying the pre-mixed crapola.)