What is the fault code for an Impala turbine shaft?
Thanks, Input and output shaft sensors or signal failure problems should throw fault codes P0717 & P0722. I have the workshop manual for this car with all the wiring diagrams, and ohms values to check etc, so i’ll give your recommendations a try…. 06 impala 3.5 95000 mi no add ons.
What are the symptoms of turbine shaft code p0717?
Because of the wave plate failure, possibly in combination with the failure mode, these transmissions would suffer from reverse gear lockout or slipping or harsh engagement in 3 rd or 5 th Gear. What are the symptoms of code P0717 ?
What to do if turbine shaft speed sensor is not working?
The TCM also monitors the turbine speed sensor itself for problems, which it would expect to find in a certain range and change speeds at a certain rate. If the TCM detects problems with the TSS or TSS circuit, it will set a diagnostic trouble code (DTC) in memory and command the ECM to illuminate the check engine light.
What kind of car has turbine shaft speed?
(Buick Century, LeSabre, Park Avenue Regal, Rendevous; Chevrolet Cavalier, Impala, Malibu, Monte Carlo, Venture, Lumina; Oldsmobile Alero, Aurora, Intrigue, Silhouette; Pontiac Bonneville, Grand Am, Grand Prix, Montana, Sunfire, Aztek)
What happens when turbine speed exceeds 127%?
This system shall not be dependent on the governing system or any other system. The system shall prevent the turbine rotor speed from exceeding 127% of the rated speed on an instantaneous, complete loss of coupled inertia and load while opening at the rated condition.
Who is Charles Rutan turbine overspeed trip protection?
TURBINE OVERSPEED TRIP PROTECTION Charles R. (Charlie) Rutan is Senior Engineering Advisor (Engineering Fellow), a position that is a shared resource with Lyondell/Equistar, in Alvin, Texas. His expertise is in the field of rotating equip- ment, hot tapping/plugging, and special problems.
What happens if the overspeed protection fails on a steam turbine?
If the overspeed trip protection of a steam turbine fails to function at the design set speed, turbine buckets or a section of a wheel can break free of the rotor and, in a worst case scenario, penetrate the turbine casing. This can cause major damage to the turbine-driven equipment with a possibility of injuries and/or fatal-
When does the 722.9 7G Matic transmission go into limp mode?
1 Check Transmission Oil Level. The 722.9 7G transmission has no oil dipstick. 2 Limp Mode. Whenever there is a problem with your transmission or certain sensors that send data to the TCU, the 7G Matic transmission goes into limp mode. 3 Rear Fault Codes. 4 Conductor Plate / Valve Body.