How to adjust automatic folding of side mirrors on Mercedes W211?
If playback doesn’t begin shortly, try restarting your device. Hidden Functions Mercedes. Opening all Windows With a Key in Two Modes on Mercedes W212 Life Hack. Encoding Mercedes / How to Change Fahrenheit to Celsius & Backward on Mercedes W212 Videos you watch may be added to the TV’s watch history and influence TV recommendations.
Why does my folding mirror not fold out?
May have been the result of condensation though. To test it remove the switch and measure the resistance across pins 2 and 5 – should be around 900 ohms. Press the fold In switch and it should be around 160 ohms. Press the fold Out switch and it should be around 0 ohms.
What should the resistance be on a folding mirror?
May have been the result of condensation though. To test it remove the switch and measure the resistance across pins 2 and 5 – should be around 900 ohms. Press the fold In switch and it should be around 160 ohms.
Why does my car mirror not adjust from top to bottom?
In some cases the mirrors will adjust from top to bottom, but when the driver tries to adjust them sideways, the mirror does not move. This is commonly caused by either an electrical malfunction inside the switch or an issue between the switch and the electrical relay that sends a signal to the motor that operates the mirror.
What to do if your folding mirror won’t fold out?
Press the fold Out switch and it should be around 0 ohms. If the mirrors are In and the Out switch doesn’t work you can also disconnect the cable from the switch and momentarily short pins 2 and 5. If the Front SAM is good the mirrors will fold out.
What are the symptoms of a bad mirror control switch?
1. Mirrors adjust up and down but not left to right 2. Mirrors adjust side to side but not up and down 3. Mirrors do not adjust at all 4. Mirrors adjust from the master (driver) switch but not the slave (passenger) switch
May have been the result of condensation though. To test it remove the switch and measure the resistance across pins 2 and 5 – should be around 900 ohms. Press the fold In switch and it should be around 160 ohms.