Why is my find and replace window closed?
If the Format or Attributes window is also open where you can’t see it, that would prevent closing the Find and Replace window. Press TAB, then press ALT+SPACEBAR.
How to close the find and replace dialog box?
Once OOo “hangs up” I don’t know of any way to get it working again. If the Format or Attributes window is also open where you can’t see it, that would prevent closing the Find and Replace window. Press TAB, then press ALT+SPACEBAR. If a menu pops up, select Move and use the arrow keys to move the window back to the screen where you can close it.
What to do if your convertible top is leaking?
If the top is leaking water, you’ll need to check the seals on the top as well as the seal that meets the top edge of the windshield. If there are any rips or cracks, replace as needed. Additionally, check the six seal sections that make up the sides of the convertible top.
Do you need to work on your convertible top?
It’s a fact, sooner or later, all convertible tops will need a bit of work. As the car ages, the convertible top is asked to withstand a variety of elements, be it heat, cold, dirt or rain. Couple this with constant stretching and releasing and you can understand how much wear and tear the overall system goes through.
What does it mean when your convertible top stops working?
It is great that you have performed the reset procedure already as that is typically the first step in diagnosis. In most cases when the electrical noise is heard and the convertible top motor is heard trying to work this indicates that the top is receiving power.
What should I do if my front door wont close?
Loosen this screw and pull the bar out from the door jamb slightly. Tighten it and try closing your door again. Continue to adjust the latch until it sets properly and your door stays closed. That pretty much sums up fixing common door problems. Next time you have an issue with your door, be sure to “Mind the Gap”.
What to do if your car top stops working?
If you have changed these parts and if the check engine light is not on but the codes remain then you should drive the vehicle for a while. it can take about 500 miles for them to clear. If… Navigation Screen is black and radio turns off every few minutes.
Why is Max not marked on convertible top?
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.