How do you change the brake pads on a 1998 ML320?
Tighten the two bolts in the back of the caliper to 23 Nm. Reinstall the rest in reverse order. Remember to put back the cap on the brake fluid reservoir. Start the car but do not drive yet. Press the brake pedal a couple of times until the pedal feels hard to press. VIDEO: How to change rear brake pads on ML320 1998-2005.
How to install new brake pads on a Mercedes medic?
Install the locking bolt and tighten to 23 Nm. Install new brake pads on the calipers. First you will need to install the inner brake pad into the piston. Then install the outer brake bad. Make sure to clean the surfaces where the brake pads slide. You will need to press the cylinder in the caliper.
How to adjust the parking brake shoes on ml?
Adjust parking brakes. Once you install the rotors, you can use a screwdriver to adjust the shoes. You will be using the lug nut hole to turn the adjusting nut we looked at earlier. You can turn the nut both ways. You will have to experiment with which way will tighten the brakes.How to adjust the parking emergency brakes on ML?
How do you replace a parking brake rotor?
Disconnect the brake wear sensor if you have one. Pull out the brake caliper with the pads. Remove the two bolts shown below. Remove the bolt that keeps the rotor centered. At this point you should be able to remove the rotor. You may want to spray a WD-40 a few times and let the sit for a while.
How to replace rear brake pads and rotors?
Step-by-step instructions on how to replace the rear brake pads and rotors on any Mercedes Benz ML320 ML430 ML350 ML500 years 1998-2005 If this is your first time doing this job plan on spending around 4 hours. Makre sure you have all your tools and parts ready. We would strongly recommend that you install ceramic brake pads and new rotors.
How to install new brake pads on a Mercedes?
Make sure you have your parking/emergency brakes released. Install new rotor. Clean the surface where the rotors seat. You can apply a thin coat of grease if you like so that removal will be easy next time. Install the locking bolt and tighten to 23 Nm. Install new brake pads on the calipers.
Tighten the two bolts in the back of the caliper to 23 Nm. Reinstall the rest in reverse order. Remember to put back the cap on the brake fluid reservoir. Start the car but do not drive yet. Press the brake pedal a couple of times until the pedal feels hard to press. VIDEO: How to change rear brake pads on ML320 1998-2005.
Step-by-step instructions on how to replace the rear brake pads and rotors on any Mercedes Benz ML320 ML430 ML350 ML500 years 1998-2005 If this is your first time doing this job plan on spending around 4 hours. Makre sure you have all your tools and parts ready. We would strongly recommend that you install ceramic brake pads and new rotors.
Make sure you have your parking/emergency brakes released. Install new rotor. Clean the surface where the rotors seat. You can apply a thin coat of grease if you like so that removal will be easy next time. Install the locking bolt and tighten to 23 Nm. Install new brake pads on the calipers.