Why does my riding mower run for 30-45 minutes then stops?
I have a Craftsman 18.o HP electric start lawn tractor model number 917.273752. A few days ago I began having a problem. The mower will run for 30-45 minutes and stop. After waiting 10 minute or so I can restart it and the whole process is repeated.
How to turn on security light without starting engine?
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
How long do you leave ignition key on while programming?
Connect a battery charger to the battery to ensure power is available while programming. Both the BCM and PCM must be working and communicating with each other. Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes.
How long does it take to relearn the ignition switch?
When performing this relearn, all previously learned keys will be erased. Additional keys may be relearned immediately after the first key has been learned by inserting the additional key and turning the ignition switch to on within 10 seconds of removing the previously learned key. Turn key to the “ON” position without starting the engine.
I have a Craftsman 18.o HP electric start lawn tractor model number 917.273752. A few days ago I began having a problem. The mower will run for 30-45 minutes and stop. After waiting 10 minute or so I can restart it and the whole process is repeated.
Why does power go away when engine gets hot?
This sounds like as the engine gets hotter the power goes away and this can happen if the fuel is vaporized in the fuel lines . Just something you might want to check . Hope this helps
What to do when SRM 225 engine stalls?
It’s not a hard job. Remove the really long screw that tightens the collar that holds the drive shaft housing. Pull out the drive shaft housing. Separate the engine from the cowling that holds drive shaft, and there the coil will be.
Why does my Briggs and Stratton engine stop after 10 minutes?
Letting it sit until it cools possibly allows enough time for air to seep in and equalize the pressure so it’s good for another 10 minute run. Is the engine sputtering and slowly dying or when it’s good and hot is it like you flipped a switch? If it’s running fine and then just dies it could be the ignition coil failing when it gets hot.
Why does my 1999 Cougar engine not restart?
Our 1999 Cougar runs fine but, randomly, after stopping and shutting down won’t restart. After 30 minutes it starts right up. It doesn’t appear to be the fuel pump.
How long does a Briggs and Stratton lawn mower run?
I then started the mower (started on first try) and began my normal mowing and unscrewing the gas cap every 5 minutes and reinstall leaving about 2 threads engagement as stated above. The mower did not stalled for the entire mowing period which normally lasted for about 35 minutes.
Why does my ATV run for a few minutes then stall?
As the engine heats up the coil looses its resistance and fails to deliver the charge needed to start the engine. Without bombarding you with technical numbers or making you buy testing equipment, I would simply run the ATV until it dies and pull the plug.
Why did my John Deere rider stop at my house?
My wife, as is her wont, was mowing while I was out of town for the week. When I called to let her know that I had arrived, she told me the John Deere rider had stopped after about 15 minutes and she had to get the neighbors to help push it back to the house. From her description, we agreed that it was either a fuel or air problem.
What kind of ATV runs Great then dies?
I have an 04 sportsman 700 Eli. It runs great for a while but then bogs down and has no power. If I shut it off then turn it back on it will run great again for a while. I would have to keep doing that all day if I want to ride.
How long does a Polaris ATV run before it dies?
It runs about 10 minutes, dies. The really weird part is that if you let it sit about 5 minutes it starts right back up again and runs great again. That is until it dies again.
How to fix an automotive engine stalling while driving?
Easy step by step guide on how to repair an automotive engine that has stalled or intermittently stalls while driving, this information is presented in order of popularity and pertains to most vehicles. Begin with the vehicle on level ground engine off (cold) with the emergency brake set.
What causes a car to start but not keep running?
The engine requires the right amount of air and fuel to mix together for ignition. If there is a fuel leak somewhere, then the correct amount of fuel may not make it to the combustion chamber. This might be enough to allow the engine to start, but not keep running.
What are the symptoms of a hard starting car?
Symptoms When key in the ignition, starts cranking very weakly. No dash lights or very dim dash lights. No electronics work or they’re very weak (e.g., window scrolls down a lot slower than normal). The interior dome light dims off.
What happens to your body when you run for 30 minutes?
More: Breathing and Running: A Lesson in Oxygen Intake and VO2 Max. As you hit your stride, your body’s biggest muscle, the gluteus maximus (i.e., your butt), your legs, and your core help keep you upright, control your gait, and extend your hip joints so your feet can push off the ground.
Why does my car not start after a short stop?
Starts most of the time, then after a few days or a week, after a short stop, it won’t start. Alternator was changed 6 months ago. New battery after the first non- start, new Neutral Safety Switch, too.
Why does my bike not start after a down time?
After a prolonged ‘down time’ and extension hose line, fuel pump, tank and battery replacement, the starter make the most horrendous gear-grinding noise, and bike won’t start. Also, I no longer hear the fuel pump engage when I turn switch ‘on’. All lights and gauges appear normal. Have I wired something backward? ReplyDelete Replies
Is it possible to ride 30 miles a day?
He completes the first day with relative ease, but notes that a 30-mile bike ride in 110-degree heat is a lot more draining than the usual 10-mile rides he’s used to. It’s not long, however, before his enthusiasm begins to dip.
How often does a GMC Yukon engine die?
Engine cranks, briefly… Engine cranks, briefly starts and then dies. The engine cranks over, the engine will start and within one second the engine dies. This occurs once every other month. Took it to dealer for a major tune up and it still happens.
What to do if your chainsaw stops running?
To find just the right part, enter your model number. We can help you find your model number right away. The spark arrestor is a small screen that prevents the engine from emitting sparks. Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the chainsaw may run s…tall or run rough.
What to do if your GMC Yukon won’t start?
No matter what I do… take the battery cable off, pull and replace fuses… etc, it just will not start However, if you wait exactly 15 minutes, it will start perfectly fine. Somebody suggested to me that the security system was kicking in and shutting off the ignition coil until it automatically cleared after 15 minutes.