What happens when a diesel engine is idle?
There is a simple check to carry out (similar to conventional) valves to check clearances. They do have precombustion chambers. When the engine is idling when cold is it at the normal revs or is it slower than normal ? Most engines will run roughly at lower than standard idle speed.
Why is idle speed not coming back up?
If the ISC system is working correctly, the PCM should adjust idle speed to keep the engine from lugging down when the A/C compressor engages. If idle speed drops down and does not come back up, the ISC system is not responding the way it should.
Can a bad idle control valve cause stalling?
This is controlled by the engine’s computer. Sometimes parts go bad, which results in your car idling strangely or stalling. Check to see if your idle control valve is functioning properly before attempting to replace it. Look for a high engine idle. A common symptom of a faulty idle control valve can be a high idle.
Why is my idle control not working on my car?
If the idle has not changed at all, it’s likely because your idle control motor has not been functioning. If the idle control motor was working, disconnecting it should have created a difference in the engine’s idle. This test confirms there’s an issue with the idle control motor, but not what the issue may be.
Why does my car idle but wont Rev?
Mahalo. If there is an electronic throttle control fault the accelerator pedal may not respond. The problem may be as simple as a brake light switch stuck on. Plug in your diagnostic scan tool and go to work. Could the issue have been as simple as replacing an old dead battery?
When to remove an idle air control valve?
Because of the nature of this valve (large air volume processed) it should be serviced when a tune up is performed to remove “coking” which will hinder the valve’s performance. To perform a rough check of the idle air control, remove the valve while reconnecting the wiring harness.
Why does the engine stall when I put the car in reverse?
If the engine stalls, it may be caused by a faulty idle control valve, bad O2 sensors, or clogged fuel injectors. In regards to the “pan”, we’re not sure what you are referring, so it may be a good idea to contact one of our local professional mechanics to complete a battery inspection to determine what’s going on with your 2010 Ford Focus.
How to troubleshoot an automotive engine high idle?
The troubleshooting procedure for high and low idle conditions are similar, which are included in the following: Step 1 – If the check engine or service engine light soon has illuminated retrieving the diagnostic trouble codes could lead you in the right direction of what the problem is, or is related too.